diff options
Diffstat (limited to 'arch/arm/mach-omap2/devices.c')
| -rw-r--r-- | arch/arm/mach-omap2/devices.c | 169 |
1 files changed, 169 insertions, 0 deletions
diff --git a/arch/arm/mach-omap2/devices.c b/arch/arm/mach-omap2/devices.c index 90af2ac469a..9d7216ff6c9 100644 --- a/arch/arm/mach-omap2/devices.c +++ b/arch/arm/mach-omap2/devices.c @@ -14,16 +14,19 @@ #include <linux/init.h> #include <linux/platform_device.h> #include <linux/io.h> +#include <linux/clk.h> #include <mach/hardware.h> #include <asm/mach-types.h> #include <asm/mach/map.h> +#include <mach/control.h> #include <mach/tc.h> #include <mach/board.h> #include <mach/mux.h> #include <mach/gpio.h> #include <mach/eac.h> +#include <mach/mmc.h> #if defined(CONFIG_OMAP_DSP) || defined(CONFIG_OMAP_DSP_MODULE) #define OMAP2_MBOX_BASE IO_ADDRESS(OMAP24XX_MAILBOX_BASE) @@ -295,6 +298,171 @@ static void omap_init_sha1_md5(void) static inline void omap_init_sha1_md5(void) { } #endif +/*-------------------------------------------------------------------------*/ + +#ifdef CONFIG_ARCH_OMAP3 + +#define MMCHS_SYSCONFIG 0x0010 +#define MMCHS_SYSCONFIG_SWRESET (1 << 1) +#define MMCHS_SYSSTATUS 0x0014 +#define MMCHS_SYSSTATUS_RESETDONE (1 << 0) + +static struct platform_device dummy_pdev = { + .dev = { + .bus = &platform_bus_type, + }, +}; + +/** + * omap_hsmmc_reset() - Full reset of each HS-MMC controller + * + * Ensure that each MMC controller is fully reset. Controllers + * left in an unknown state (by bootloader) may prevent retention + * or OFF-mode. This is especially important in cases where the + * MMC driver is not enabled, _or_ built as a module. + * + * In order for reset to work, interface, functional and debounce + * clocks must be enabled. The debounce clock comes from func_32k_clk + * and is not under SW control, so we only enable i- and f-clocks. + **/ +static void __init omap_hsmmc_reset(void) +{ + u32 i, nr_controllers = cpu_is_omap34xx() ? OMAP34XX_NR_MMC : + OMAP24XX_NR_MMC; + + for (i = 0; i < nr_controllers; i++) { + u32 v, base = 0; + struct clk *iclk, *fclk; + struct device *dev = &dummy_pdev.dev; + + switch (i) { + case 0: + base = OMAP2_MMC1_BASE; + break; + case 1: + base = OMAP2_MMC2_BASE; + break; + case 2: + base = OMAP3_MMC3_BASE; + break; + } + + dummy_pdev.id = i; + iclk = clk_get(dev, "mmchs_ick"); + if (iclk && clk_enable(iclk)) + iclk = NULL; + + fclk = clk_get(dev, "mmchs_fck"); + if (fclk && clk_enable(fclk)) + fclk = NULL; + + if (!iclk || !fclk) { + printk(KERN_WARNING + "%s: Unable to enable clocks for MMC%d, " + "cannot reset.\n", __func__, i); + break; + } + + omap_writel(MMCHS_SYSCONFIG_SWRESET, base + MMCHS_SYSCONFIG); + v = omap_readl(base + MMCHS_SYSSTATUS); + while (!(omap_readl(base + MMCHS_SYSSTATUS) & + MMCHS_SYSSTATUS_RESETDONE)) + cpu_relax(); + + if (fclk) { + clk_disable(fclk); + clk_put(fclk); + } + if (iclk) { + clk_disable(iclk); + clk_put(iclk); + } + } +} +#else +static inline void omap_hsmmc_reset(void) {} +#endif + +#if defined(CONFIG_MMC_OMAP) || defined(CONFIG_MMC_OMAP_MODULE) || \ + defined(CONFIG_MMC_OMAP_HS) || defined(CONFIG_MMC_OMAP_HS_MODULE) + +static inline void omap2_mmc_mux(struct omap_mmc_platform_data *mmc_controller, + int controller_nr) +{ + if (cpu_is_omap2420() && controller_nr == 0) { + omap_cfg_reg(H18_24XX_MMC_CMD); + omap_cfg_reg(H15_24XX_MMC_CLKI); + omap_cfg_reg(G19_24XX_MMC_CLKO); + omap_cfg_reg(F20_24XX_MMC_DAT0); + omap_cfg_reg(F19_24XX_MMC_DAT_DIR0); + omap_cfg_reg(G18_24XX_MMC_CMD_DIR); + if (mmc_controller->slots[0].wires == 4) { + omap_cfg_reg(H14_24XX_MMC_DAT1); + omap_cfg_reg(E19_24XX_MMC_DAT2); + omap_cfg_reg(D19_24XX_MMC_DAT3); + omap_cfg_reg(E20_24XX_MMC_DAT_DIR1); + omap_cfg_reg(F18_24XX_MMC_DAT_DIR2); + omap_cfg_reg(E18_24XX_MMC_DAT_DIR3); + } + + /* + * Use internal loop-back in MMC/SDIO Module Input Clock + * selection + */ + if (mmc_controller->slots[0].internal_clock) { + u32 v = omap_ctrl_readl(OMAP2_CONTROL_DEVCONF0); + v |= (1 << 24); + omap_ctrl_writel(v, OMAP2_CONTROL_DEVCONF0); + } + } +} + +void __init omap2_init_mmc(struct omap_mmc_platform_data **mmc_data, + int nr_controllers) +{ + int i; + + for (i = 0; i < nr_controllers; i++) { + unsigned long base, size; + unsigned int irq = 0; + + if (!mmc_data[i]) + continue; + + omap2_mmc_mux(mmc_data[i], i); + + switch (i) { + case 0: + base = OMAP2_MMC1_BASE; + irq = INT_24XX_MMC_IRQ; + break; + case 1: + base = OMAP2_MMC2_BASE; + irq = INT_24XX_MMC2_IRQ; + break; + case 2: + if (!cpu_is_omap34xx()) + return; + base = OMAP3_MMC3_BASE; + irq = INT_34XX_MMC3_IRQ; + break; + default: + continue; + } + + if (cpu_is_omap2420()) + size = OMAP2420_MMC_SIZE; + else + size = HSMMC_SIZE; + + omap_mmc_add(i, base, size, irq, mmc_data[i]); + }; +} + +#endif + +/*-------------------------------------------------------------------------*/ + #if defined(CONFIG_HDQ_MASTER_OMAP) || defined(CONFIG_HDQ_MASTER_OMAP_MODULE) #if defined(CONFIG_ARCH_OMAP2430) || defined(CONFIG_ARCH_OMAP3430) #define OMAP_HDQ_BASE 0x480B2000 @@ -334,6 +502,7 @@ static int __init omap2_init_devices(void) /* please keep these calls, and their implementations above, * in alphabetical order so they're easier to sort through. */ + omap_hsmmc_reset(); omap_init_mbox(); omap_init_mcspi(); omap_hdq_init(); |