aboutsummaryrefslogtreecommitdiff
path: root/arch/i386/xen
diff options
context:
space:
mode:
Diffstat (limited to 'arch/i386/xen')
-rw-r--r--arch/i386/xen/enlighten.c1
-rw-r--r--arch/i386/xen/xen-asm.S185
-rw-r--r--arch/i386/xen/xen-ops.h1
3 files changed, 183 insertions, 4 deletions
diff --git a/arch/i386/xen/enlighten.c b/arch/i386/xen/enlighten.c
index 4fa62a4cb7c..9a8c1181c00 100644
--- a/arch/i386/xen/enlighten.c
+++ b/arch/i386/xen/enlighten.c
@@ -838,6 +838,7 @@ void __init xen_setup_vcpu_info_placement(void)
paravirt_ops.irq_disable = xen_irq_disable_direct;
paravirt_ops.irq_enable = xen_irq_enable_direct;
paravirt_ops.read_cr2 = xen_read_cr2_direct;
+ paravirt_ops.iret = xen_iret_direct;
}
}
diff --git a/arch/i386/xen/xen-asm.S b/arch/i386/xen/xen-asm.S
index dc4d36d51bc..1a43b60c0c6 100644
--- a/arch/i386/xen/xen-asm.S
+++ b/arch/i386/xen/xen-asm.S
@@ -12,15 +12,21 @@
*/
#include <linux/linkage.h>
+
#include <asm/asm-offsets.h>
#include <asm/thread_info.h>
#include <asm/percpu.h>
-#include <asm/asm-offsets.h>
#include <asm/processor-flags.h>
+#include <asm/segment.h>
+
+#include <xen/interface/xen.h>
#define RELOC(x, v) .globl x##_reloc; x##_reloc=v
#define ENDPATCH(x) .globl x##_end; x##_end=.
+/* Pseudo-flag used for virtual NMI, which we don't implement yet */
+#define XEN_EFLAGS_NMI 0x80000000
+
/*
Enable events. This clears the event mask and tests the pending
event status with one and operation. If there are pending
@@ -81,13 +87,12 @@ ENDPATCH(xen_save_fl_direct)
*/
ENTRY(xen_restore_fl_direct)
testb $X86_EFLAGS_IF>>8, %ah
- setz %al
- movb %al, PER_CPU_VAR(xen_vcpu_info)+XEN_vcpu_info_mask
+ setz PER_CPU_VAR(xen_vcpu_info)+XEN_vcpu_info_mask
/* Preempt here doesn't matter because that will deal with
any pending interrupts. The pending check may end up being
run on the wrong CPU, but that doesn't hurt. */
- /* check for pending but unmasked */
+ /* check for unmasked and pending */
cmpw $0x0001, PER_CPU_VAR(xen_vcpu_info)+XEN_vcpu_info_pending
jz 1f
2: call check_events
@@ -97,6 +102,178 @@ ENDPATCH(xen_restore_fl_direct)
ENDPROC(xen_restore_fl_direct)
RELOC(xen_restore_fl_direct, 2b+1)
+/*
+ This is run where a normal iret would be run, with the same stack setup:
+ 8: eflags
+ 4: cs
+ esp-> 0: eip
+
+ This attempts to make sure that any pending events are dealt
+ with on return to usermode, but there is a small window in
+ which an event can happen just before entering usermode. If
+ the nested interrupt ends up setting one of the TIF_WORK_MASK
+ pending work flags, they will not be tested again before
+ returning to usermode. This means that a process can end up
+ with pending work, which will be unprocessed until the process
+ enters and leaves the kernel again, which could be an
+ unbounded amount of time. This means that a pending signal or
+ reschedule event could be indefinitely delayed.
+
+ The fix is to notice a nested interrupt in the critical
+ window, and if one occurs, then fold the nested interrupt into
+ the current interrupt stack frame, and re-process it
+ iteratively rather than recursively. This means that it will
+ exit via the normal path, and all pending work will be dealt
+ with appropriately.
+
+ Because the nested interrupt handler needs to deal with the
+ current stack state in whatever form its in, we keep things
+ simple by only using a single register which is pushed/popped
+ on the stack.
+
+ Non-direct iret could be done in the same way, but it would
+ require an annoying amount of code duplication. We'll assume
+ that direct mode will be the common case once the hypervisor
+ support becomes commonplace.
+ */
+ENTRY(xen_iret_direct)
+ /* test eflags for special cases */
+ testl $(X86_EFLAGS_VM | XEN_EFLAGS_NMI), 8(%esp)
+ jnz hyper_iret
+
+ push %eax
+ ESP_OFFSET=4 # bytes pushed onto stack
+
+ /* Store vcpu_info pointer for easy access. Do it this
+ way to avoid having to reload %fs */
+#ifdef CONFIG_SMP
+ GET_THREAD_INFO(%eax)
+ movl TI_cpu(%eax),%eax
+ movl __per_cpu_offset(,%eax,4),%eax
+ lea per_cpu__xen_vcpu_info(%eax),%eax
+#else
+ movl $per_cpu__xen_vcpu_info, %eax
+#endif
+
+ /* check IF state we're restoring */
+ testb $X86_EFLAGS_IF>>8, 8+1+ESP_OFFSET(%esp)
+
+ /* Maybe enable events. Once this happens we could get a
+ recursive event, so the critical region starts immediately
+ afterwards. However, if that happens we don't end up
+ resuming the code, so we don't have to be worried about
+ being preempted to another CPU. */
+ setz XEN_vcpu_info_mask(%eax)
+xen_iret_start_crit:
+
+ /* check for unmasked and pending */
+ cmpw $0x0001, XEN_vcpu_info_pending(%eax)
+
+ /* If there's something pending, mask events again so we
+ can jump back into xen_hypervisor_callback */
+ sete XEN_vcpu_info_mask(%eax)
+
+ popl %eax
+
+ /* From this point on the registers are restored and the stack
+ updated, so we don't need to worry about it if we're preempted */
+iret_restore_end:
+
+ /* Jump to hypervisor_callback after fixing up the stack.
+ Events are masked, so jumping out of the critical
+ region is OK. */
+ je xen_hypervisor_callback
+
+ iret
+xen_iret_end_crit:
+
+hyper_iret:
+ /* put this out of line since its very rarely used */
+ jmp hypercall_page + __HYPERVISOR_iret * 32
+
+ .globl xen_iret_start_crit, xen_iret_end_crit
+
+/*
+ This is called by xen_hypervisor_callback in entry.S when it sees
+ that the EIP at the time of interrupt was between xen_iret_start_crit
+ and xen_iret_end_crit. We're passed the EIP in %eax so we can do
+ a more refined determination of what to do.
+
+ The stack format at this point is:
+ ----------------
+ ss : (ss/esp may be present if we came from usermode)
+ esp :
+ eflags } outer exception info
+ cs }
+ eip }
+ ---------------- <- edi (copy dest)
+ eax : outer eax if it hasn't been restored
+ ----------------
+ eflags } nested exception info
+ cs } (no ss/esp because we're nested
+ eip } from the same ring)
+ orig_eax }<- esi (copy src)
+ - - - - - - - -
+ fs }
+ es }
+ ds } SAVE_ALL state
+ eax }
+ : :
+ ebx }
+ ----------------
+ return addr <- esp
+ ----------------
+
+ In order to deliver the nested exception properly, we need to shift
+ everything from the return addr up to the error code so it
+ sits just under the outer exception info. This means that when we
+ handle the exception, we do it in the context of the outer exception
+ rather than starting a new one.
+
+ The only caveat is that if the outer eax hasn't been
+ restored yet (ie, it's still on stack), we need to insert
+ its value into the SAVE_ALL state before going on, since
+ it's usermode state which we eventually need to restore.
+ */
+ENTRY(xen_iret_crit_fixup)
+ /* offsets +4 for return address */
+
+ /*
+ Paranoia: Make sure we're really coming from userspace.
+ One could imagine a case where userspace jumps into the
+ critical range address, but just before the CPU delivers a GP,
+ it decides to deliver an interrupt instead. Unlikely?
+ Definitely. Easy to avoid? Yes. The Intel documents
+ explicitly say that the reported EIP for a bad jump is the
+ jump instruction itself, not the destination, but some virtual
+ environments get this wrong.
+ */
+ movl PT_CS+4(%esp), %ecx
+ andl $SEGMENT_RPL_MASK, %ecx
+ cmpl $USER_RPL, %ecx
+ je 2f
+
+ lea PT_ORIG_EAX+4(%esp), %esi
+ lea PT_EFLAGS+4(%esp), %edi
+
+ /* If eip is before iret_restore_end then stack
+ hasn't been restored yet. */
+ cmp $iret_restore_end, %eax
+ jae 1f
+
+ movl 0+4(%edi),%eax /* copy EAX */
+ movl %eax, PT_EAX+4(%esp)
+
+ lea ESP_OFFSET(%edi),%edi /* move dest up over saved regs */
+
+ /* set up the copy */
+1: std
+ mov $(PT_EIP+4) / 4, %ecx /* copy ret+saved regs up to orig_eax */
+ rep movsl
+ cld
+
+ lea 4(%edi),%esp /* point esp to new frame */
+2: ret
/*
diff --git a/arch/i386/xen/xen-ops.h b/arch/i386/xen/xen-ops.h
index 33e4c8a1628..b9aaea45f07 100644
--- a/arch/i386/xen/xen-ops.h
+++ b/arch/i386/xen/xen-ops.h
@@ -67,4 +67,5 @@ DECL_ASM(void, xen_irq_disable_direct, void);
DECL_ASM(unsigned long, xen_save_fl_direct, void);
DECL_ASM(void, xen_restore_fl_direct, unsigned long);
+void xen_iret_direct(void);
#endif /* XEN_OPS_H */