diff options
Diffstat (limited to 'drivers/net/jme.c')
-rw-r--r-- | drivers/net/jme.c | 71 |
1 files changed, 29 insertions, 42 deletions
diff --git a/drivers/net/jme.c b/drivers/net/jme.c index 665e70d620f..08b34051c64 100644 --- a/drivers/net/jme.c +++ b/drivers/net/jme.c @@ -435,15 +435,18 @@ jme_check_link(struct net_device *netdev, int testonly) GHC_DPX); switch (phylink & PHY_LINK_SPEED_MASK) { case PHY_LINK_SPEED_10M: - ghc |= GHC_SPEED_10M; + ghc |= GHC_SPEED_10M | + GHC_TO_CLK_PCIE | GHC_TXMAC_CLK_PCIE; strcat(linkmsg, "10 Mbps, "); break; case PHY_LINK_SPEED_100M: - ghc |= GHC_SPEED_100M; + ghc |= GHC_SPEED_100M | + GHC_TO_CLK_PCIE | GHC_TXMAC_CLK_PCIE; strcat(linkmsg, "100 Mbps, "); break; case PHY_LINK_SPEED_1000M: - ghc |= GHC_SPEED_1000M; + ghc |= GHC_SPEED_1000M | + GHC_TO_CLK_GPHY | GHC_TXMAC_CLK_GPHY; strcat(linkmsg, "1000 Mbps, "); break; default: @@ -463,14 +466,6 @@ jme_check_link(struct net_device *netdev, int testonly) TXTRHD_TXREN | ((8 << TXTRHD_TXRL_SHIFT) & TXTRHD_TXRL)); } - strcat(linkmsg, (phylink & PHY_LINK_DUPLEX) ? - "Full-Duplex, " : - "Half-Duplex, "); - - if (phylink & PHY_LINK_MDI_STAT) - strcat(linkmsg, "MDI-X"); - else - strcat(linkmsg, "MDI"); gpreg1 = GPREG1_DEFAULT; if (is_buggy250(jme->pdev->device, jme->chiprev)) { @@ -492,11 +487,17 @@ jme_check_link(struct net_device *netdev, int testonly) break; } } - jwrite32(jme, JME_GPREG1, gpreg1); - jme->reg_ghc = ghc; + jwrite32(jme, JME_GPREG1, gpreg1); jwrite32(jme, JME_GHC, ghc); + jme->reg_ghc = ghc; + strcat(linkmsg, (phylink & PHY_LINK_DUPLEX) ? + "Full-Duplex, " : + "Half-Duplex, "); + strcat(linkmsg, (phylink & PHY_LINK_MDI_STAT) ? + "MDI-X" : + "MDI"); msg_link(jme, "Link is up at %s.\n", linkmsg); netif_carrier_on(netdev); } else { @@ -931,7 +932,6 @@ jme_alloc_and_feed_skb(struct jme_adapter *jme, int idx) cpu_to_le16(RXWBFLAG_DEST_MUL)) ++(NET_STAT(jme).multicast); - jme->dev->last_rx = jiffies; NET_STAT(jme).rx_bytes += framesize; ++(NET_STAT(jme).rx_packets); } @@ -1250,7 +1250,6 @@ static int jme_poll(JME_NAPI_HOLDER(holder), JME_NAPI_WEIGHT(budget)) { struct jme_adapter *jme = jme_napi_priv(holder); - struct net_device *netdev = jme->dev; int rest; rest = jme_process_receive(jme, JME_NAPI_WEIGHT_VAL(budget)); @@ -2591,14 +2590,6 @@ static const struct ethtool_ops jme_ethtool_ops = { static int jme_pci_dma64(struct pci_dev *pdev) { - if (!pci_set_dma_mask(pdev, DMA_64BIT_MASK)) - if (!pci_set_consistent_dma_mask(pdev, DMA_64BIT_MASK)) - return 1; - - if (!pci_set_dma_mask(pdev, DMA_40BIT_MASK)) - if (!pci_set_consistent_dma_mask(pdev, DMA_40BIT_MASK)) - return 1; - if (!pci_set_dma_mask(pdev, DMA_32BIT_MASK)) if (!pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK)) return 0; @@ -2626,6 +2617,18 @@ jme_check_hw_ver(struct jme_adapter *jme) jme->chiprev = (chipmode & CM_CHIPREV_MASK) >> CM_CHIPREV_SHIFT; } +static const struct net_device_ops jme_netdev_ops = { + .ndo_open = jme_open, + .ndo_stop = jme_close, + .ndo_validate_addr = eth_validate_addr, + .ndo_start_xmit = jme_start_xmit, + .ndo_set_mac_address = jme_set_macaddr, + .ndo_set_multicast_list = jme_set_multi, + .ndo_change_mtu = jme_change_mtu, + .ndo_tx_timeout = jme_tx_timeout, + .ndo_vlan_rx_register = jme_vlan_rx_register, +}; + static int __devinit jme_init_one(struct pci_dev *pdev, const struct pci_device_id *ent) @@ -2675,17 +2678,9 @@ jme_init_one(struct pci_dev *pdev, rc = -ENOMEM; goto err_out_release_regions; } - netdev->open = jme_open; - netdev->stop = jme_close; - netdev->hard_start_xmit = jme_start_xmit; - netdev->set_mac_address = jme_set_macaddr; - netdev->set_multicast_list = jme_set_multi; - netdev->change_mtu = jme_change_mtu; + netdev->netdev_ops = &jme_netdev_ops; netdev->ethtool_ops = &jme_ethtool_ops; - netdev->tx_timeout = jme_tx_timeout; netdev->watchdog_timeo = TX_TIMEOUT; - netdev->vlan_rx_register = jme_vlan_rx_register; - NETDEV_GET_STATS(netdev, &jme_get_stats); netdev->features = NETIF_F_HW_CSUM | NETIF_F_SG | NETIF_F_TSO | @@ -2861,18 +2856,10 @@ jme_init_one(struct pci_dev *pdev, goto err_out_free_shadow; } - msg_probe(jme, - "JMC250 gigabit%s ver:%x rev:%x " - "macaddr:%02x:%02x:%02x:%02x:%02x:%02x\n", + msg_probe(jme, "JMC250 gigabit%s ver:%x rev:%x macaddr:%pM\n", (jme->fpgaver != 0) ? " (FPGA)" : "", (jme->fpgaver != 0) ? jme->fpgaver : jme->chiprev, - jme->rev, - netdev->dev_addr[0], - netdev->dev_addr[1], - netdev->dev_addr[2], - netdev->dev_addr[3], - netdev->dev_addr[4], - netdev->dev_addr[5]); + jme->rev, netdev->dev_addr); return 0; |