diff options
Diffstat (limited to 'drivers/net')
| -rw-r--r-- | drivers/net/gianfar.c | 27 | ||||
| -rw-r--r-- | drivers/net/gianfar.h | 1 | ||||
| -rw-r--r-- | drivers/net/gianfar_mii.c | 38 | ||||
| -rw-r--r-- | drivers/net/gianfar_mii.h | 3 |
4 files changed, 50 insertions, 19 deletions
diff --git a/drivers/net/gianfar.c b/drivers/net/gianfar.c index 99a4b990939..587afe7be68 100644 --- a/drivers/net/gianfar.c +++ b/drivers/net/gianfar.c @@ -131,8 +131,6 @@ static void free_skb_resources(struct gfar_private *priv); static void gfar_set_multi(struct net_device *dev); static void gfar_set_hash_for_addr(struct net_device *dev, u8 *addr); static void gfar_configure_serdes(struct net_device *dev); -extern int gfar_local_mdio_write(struct gfar_mii __iomem *regs, int mii_id, int regnum, u16 value); -extern int gfar_local_mdio_read(struct gfar_mii __iomem *regs, int mii_id, int regnum); #ifdef CONFIG_GFAR_NAPI static int gfar_poll(struct napi_struct *napi, int budget); #endif @@ -477,24 +475,30 @@ static int init_phy(struct net_device *dev) return 0; } +/* + * Initialize TBI PHY interface for communicating with the + * SERDES lynx PHY on the chip. We communicate with this PHY + * through the MDIO bus on each controller, treating it as a + * "normal" PHY at the address found in the TBIPA register. We assume + * that the TBIPA register is valid. Either the MDIO bus code will set + * it to a value that doesn't conflict with other PHYs on the bus, or the + * value doesn't matter, as there are no other PHYs on the bus. + */ static void gfar_configure_serdes(struct net_device *dev) { struct gfar_private *priv = netdev_priv(dev); struct gfar_mii __iomem *regs = (void __iomem *)&priv->regs->gfar_mii_regs; + int tbipa = gfar_read(&priv->regs->tbipa); - /* Initialise TBI i/f to communicate with serdes (lynx phy) */ + /* Single clk mode, mii mode off(for serdes communication) */ + gfar_local_mdio_write(regs, tbipa, MII_TBICON, TBICON_CLK_SELECT); - /* Single clk mode, mii mode off(for aerdes communication) */ - gfar_local_mdio_write(regs, TBIPA_VALUE, MII_TBICON, TBICON_CLK_SELECT); - - /* Supported pause and full-duplex, no half-duplex */ - gfar_local_mdio_write(regs, TBIPA_VALUE, MII_ADVERTISE, + gfar_local_mdio_write(regs, tbipa, MII_ADVERTISE, ADVERTISE_1000XFULL | ADVERTISE_1000XPAUSE | ADVERTISE_1000XPSE_ASYM); - /* ANEG enable, restart ANEG, full duplex mode, speed[1] set */ - gfar_local_mdio_write(regs, TBIPA_VALUE, MII_BMCR, BMCR_ANENABLE | + gfar_local_mdio_write(regs, tbipa, MII_BMCR, BMCR_ANENABLE | BMCR_ANRESTART | BMCR_FULLDPLX | BMCR_SPEED1000); } @@ -541,9 +545,6 @@ static void init_registers(struct net_device *dev) /* Initialize the Minimum Frame Length Register */ gfar_write(&priv->regs->minflr, MINFLR_INIT_SETTINGS); - - /* Assign the TBI an address which won't conflict with the PHYs */ - gfar_write(&priv->regs->tbipa, TBIPA_VALUE); } diff --git a/drivers/net/gianfar.h b/drivers/net/gianfar.h index 0d088360946..fd487be3993 100644 --- a/drivers/net/gianfar.h +++ b/drivers/net/gianfar.h @@ -137,7 +137,6 @@ extern const char gfar_driver_version[]; #define DEFAULT_RXCOUNT 0 #endif /* CONFIG_GFAR_NAPI */ -#define TBIPA_VALUE 0x1f #define MIIMCFG_INIT_VALUE 0x00000007 #define MIIMCFG_RESET 0x80000000 #define MIIMIND_BUSY 0x00000001 diff --git a/drivers/net/gianfar_mii.c b/drivers/net/gianfar_mii.c index b8898927236..ebcfb27a904 100644 --- a/drivers/net/gianfar_mii.c +++ b/drivers/net/gianfar_mii.c @@ -78,7 +78,6 @@ int gfar_local_mdio_write(struct gfar_mii __iomem *regs, int mii_id, * same as system mdio bus, used for controlling the external PHYs, for eg. */ int gfar_local_mdio_read(struct gfar_mii __iomem *regs, int mii_id, int regnum) - { u16 value; @@ -122,7 +121,7 @@ int gfar_mdio_read(struct mii_bus *bus, int mii_id, int regnum) } /* Reset the MIIM registers, and wait for the bus to free */ -int gfar_mdio_reset(struct mii_bus *bus) +static int gfar_mdio_reset(struct mii_bus *bus) { struct gfar_mii __iomem *regs = (void __iomem *)bus->priv; unsigned int timeout = PHY_INIT_TIMEOUT; @@ -152,14 +151,15 @@ int gfar_mdio_reset(struct mii_bus *bus) } -int gfar_mdio_probe(struct device *dev) +static int gfar_mdio_probe(struct device *dev) { struct platform_device *pdev = to_platform_device(dev); struct gianfar_mdio_data *pdata; struct gfar_mii __iomem *regs; + struct gfar __iomem *enet_regs; struct mii_bus *new_bus; struct resource *r; - int err = 0; + int i, err = 0; if (NULL == dev) return -EINVAL; @@ -199,6 +199,34 @@ int gfar_mdio_probe(struct device *dev) new_bus->dev = dev; dev_set_drvdata(dev, new_bus); + /* + * This is mildly evil, but so is our hardware for doing this. + * Also, we have to cast back to struct gfar_mii because of + * definition weirdness done in gianfar.h. + */ + enet_regs = (struct gfar __iomem *) + ((char *)regs - offsetof(struct gfar, gfar_mii_regs)); + + /* Scan the bus, looking for an empty spot for TBIPA */ + gfar_write(&enet_regs->tbipa, 0); + for (i = PHY_MAX_ADDR; i > 0; i--) { + u32 phy_id; + int r; + + r = get_phy_id(new_bus, i, &phy_id); + if (r) + return r; + + if (phy_id == 0xffffffff) + break; + } + + /* The bus is full. We don't support using 31 PHYs, sorry */ + if (i == 0) + return -EBUSY; + + gfar_write(&enet_regs->tbipa, i); + err = mdiobus_register(new_bus); if (0 != err) { @@ -218,7 +246,7 @@ reg_map_fail: } -int gfar_mdio_remove(struct device *dev) +static int gfar_mdio_remove(struct device *dev) { struct mii_bus *bus = dev_get_drvdata(dev); diff --git a/drivers/net/gianfar_mii.h b/drivers/net/gianfar_mii.h index b373091c703..2af28b16a0e 100644 --- a/drivers/net/gianfar_mii.h +++ b/drivers/net/gianfar_mii.h @@ -41,6 +41,9 @@ struct gfar_mii { int gfar_mdio_read(struct mii_bus *bus, int mii_id, int regnum); int gfar_mdio_write(struct mii_bus *bus, int mii_id, int regnum, u16 value); +int gfar_local_mdio_write(struct gfar_mii __iomem *regs, int mii_id, + int regnum, u16 value); +int gfar_local_mdio_read(struct gfar_mii __iomem *regs, int mii_id, int regnum); int __init gfar_mdio_init(void); void gfar_mdio_exit(void); #endif /* GIANFAR_PHY_H */ |