diff options
Diffstat (limited to 'drivers')
| -rw-r--r-- | drivers/net/Kconfig | 11 | ||||
| -rw-r--r-- | drivers/net/via-rhine.c | 27 |
2 files changed, 2 insertions, 36 deletions
diff --git a/drivers/net/Kconfig b/drivers/net/Kconfig index 50ca1cf1271..fb618b6e88e 100644 --- a/drivers/net/Kconfig +++ b/drivers/net/Kconfig @@ -1694,17 +1694,6 @@ config VIA_RHINE_MMIO If unsure, say Y. -config VIA_RHINE_NAPI - bool "Use Rx Polling (NAPI)" - depends on VIA_RHINE - help - NAPI is a new driver API designed to reduce CPU and interrupt load - when the driver is receiving lots of packets from the card. - - If your estimated Rx load is 10kpps or more, or if the card will be - deployed on potentially unfriendly networks (e.g. in a firewall), - then say Y here. - config LAN_SAA9730 bool "Philips SAA9730 Ethernet support" depends on NET_PCI && PCI && MIPS_ATLAS diff --git a/drivers/net/via-rhine.c b/drivers/net/via-rhine.c index 8c9d6ae2bb3..96dff04334b 100644 --- a/drivers/net/via-rhine.c +++ b/drivers/net/via-rhine.c @@ -73,12 +73,7 @@ static const int multicast_filter_limit = 32; There are no ill effects from too-large receive rings. */ #define TX_RING_SIZE 16 #define TX_QUEUE_LEN 10 /* Limit ring entries actually used. */ -#ifdef CONFIG_VIA_RHINE_NAPI #define RX_RING_SIZE 64 -#else -#define RX_RING_SIZE 16 -#endif - /* Operational parameters that usually are not changed. */ @@ -583,7 +578,6 @@ static void rhine_poll(struct net_device *dev) } #endif -#ifdef CONFIG_VIA_RHINE_NAPI static int rhine_napipoll(struct napi_struct *napi, int budget) { struct rhine_private *rp = container_of(napi, struct rhine_private, napi); @@ -604,7 +598,6 @@ static int rhine_napipoll(struct napi_struct *napi, int budget) } return work_done; } -#endif static void __devinit rhine_hw_init(struct net_device *dev, long pioaddr) { @@ -784,9 +777,8 @@ static int __devinit rhine_init_one(struct pci_dev *pdev, #ifdef CONFIG_NET_POLL_CONTROLLER dev->poll_controller = rhine_poll; #endif -#ifdef CONFIG_VIA_RHINE_NAPI netif_napi_add(dev, &rp->napi, rhine_napipoll, 64); -#endif + if (rp->quirks & rqRhineI) dev->features |= NETIF_F_SG|NETIF_F_HW_CSUM; @@ -1056,9 +1048,7 @@ static void init_registers(struct net_device *dev) rhine_set_rx_mode(dev); -#ifdef CONFIG_VIA_RHINE_NAPI napi_enable(&rp->napi); -#endif /* Enable interrupts by setting the interrupt mask. */ iowrite16(IntrRxDone | IntrRxErr | IntrRxEmpty| IntrRxOverflow | @@ -1193,9 +1183,7 @@ static void rhine_tx_timeout(struct net_device *dev) /* protect against concurrent rx interrupts */ disable_irq(rp->pdev->irq); -#ifdef CONFIG_VIA_RHINE_NAPI napi_disable(&rp->napi); -#endif spin_lock(&rp->lock); @@ -1319,16 +1307,12 @@ static irqreturn_t rhine_interrupt(int irq, void *dev_instance) if (intr_status & (IntrRxDone | IntrRxErr | IntrRxDropped | IntrRxWakeUp | IntrRxEmpty | IntrRxNoBuf)) { -#ifdef CONFIG_VIA_RHINE_NAPI iowrite16(IntrTxAborted | IntrTxDone | IntrTxError | IntrTxUnderrun | IntrPCIErr | IntrStatsMax | IntrLinkChange, ioaddr + IntrEnable); netif_rx_schedule(dev, &rp->napi); -#else - rhine_rx(dev, RX_RING_SIZE); -#endif } if (intr_status & (IntrTxErrSummary | IntrTxDone)) { @@ -1520,11 +1504,7 @@ static int rhine_rx(struct net_device *dev, int limit) PCI_DMA_FROMDEVICE); } skb->protocol = eth_type_trans(skb, dev); -#ifdef CONFIG_VIA_RHINE_NAPI netif_receive_skb(skb); -#else - netif_rx(skb); -#endif dev->last_rx = jiffies; rp->stats.rx_bytes += pkt_len; rp->stats.rx_packets++; @@ -1836,9 +1816,7 @@ static int rhine_close(struct net_device *dev) spin_lock_irq(&rp->lock); netif_stop_queue(dev); -#ifdef CONFIG_VIA_RHINE_NAPI napi_disable(&rp->napi); -#endif if (debug > 1) printk(KERN_DEBUG "%s: Shutting down ethercard, " @@ -1937,9 +1915,8 @@ static int rhine_suspend(struct pci_dev *pdev, pm_message_t state) if (!netif_running(dev)) return 0; -#ifdef CONFIG_VIA_RHINE_NAPI napi_disable(&rp->napi); -#endif + netif_device_detach(dev); pci_save_state(pdev); |