diff options
Diffstat (limited to 'include/net')
| -rw-r--r-- | include/net/mac80211.h | 77 |
1 files changed, 35 insertions, 42 deletions
diff --git a/include/net/mac80211.h b/include/net/mac80211.h index 446dbf75a1c..38dc1cd1027 100644 --- a/include/net/mac80211.h +++ b/include/net/mac80211.h @@ -149,6 +149,13 @@ struct ieee80211_low_level_stats { * @BSS_CHANGED_ERP_SLOT: slot timing changed * @BSS_CHANGED_HT: 802.11n parameters changed * @BSS_CHANGED_BASIC_RATES: Basic rateset changed + * @BSS_CHANGED_BEACON_INT: Beacon interval changed + * @BSS_CHANGED_BSSID: BSSID changed, for whatever + * reason (IBSS and managed mode) + * @BSS_CHANGED_BEACON: Beacon data changed, retrieve + * new beacon (beaconing modes) + * @BSS_CHANGED_BEACON_ENABLED: Beaconing should be + * enabled/disabled (beaconing modes) */ enum ieee80211_bss_change { BSS_CHANGED_ASSOC = 1<<0, @@ -157,6 +164,10 @@ enum ieee80211_bss_change { BSS_CHANGED_ERP_SLOT = 1<<3, BSS_CHANGED_HT = 1<<4, BSS_CHANGED_BASIC_RATES = 1<<5, + BSS_CHANGED_BEACON_INT = 1<<6, + BSS_CHANGED_BSSID = 1<<7, + BSS_CHANGED_BEACON = 1<<8, + BSS_CHANGED_BEACON_ENABLED = 1<<9, }; /** @@ -190,8 +201,11 @@ struct ieee80211_bss_ht_conf { * @basic_rates: bitmap of basic rates, each bit stands for an * index into the rate table configured by the driver in * the current band. + * @bssid: The BSSID for this BSS + * @enable_beacon: whether beaconing should be enabled or not */ struct ieee80211_bss_conf { + const u8 *bssid; /* association related data */ bool assoc; u16 aid; @@ -199,6 +213,7 @@ struct ieee80211_bss_conf { bool use_cts_prot; bool use_short_preamble; bool use_short_slot; + bool enable_beacon; u8 dtim_period; u16 beacon_int; u16 assoc_capability; @@ -518,10 +533,16 @@ struct ieee80211_rx_status { * * @IEEE80211_CONF_RADIOTAP: add radiotap header at receive time (if supported) * @IEEE80211_CONF_PS: Enable 802.11 power save mode (managed mode only) + * @IEEE80211_CONF_IDLE: The device is running, but idle; if the flag is set + * the driver should be prepared to handle configuration requests but + * may turn the device off as much as possible. Typically, this flag will + * be set when an interface is set UP but not associated or scanning, but + * it can also be unset in that case when monitor interfaces are active. */ enum ieee80211_conf_flags { IEEE80211_CONF_RADIOTAP = (1<<0), IEEE80211_CONF_PS = (1<<1), + IEEE80211_CONF_IDLE = (1<<2), }; @@ -529,25 +550,35 @@ enum ieee80211_conf_flags { * enum ieee80211_conf_changed - denotes which configuration changed * * @IEEE80211_CONF_CHANGE_RADIO_ENABLED: the value of radio_enabled changed - * @IEEE80211_CONF_CHANGE_BEACON_INTERVAL: the beacon interval changed + * @_IEEE80211_CONF_CHANGE_BEACON_INTERVAL: DEPRECATED * @IEEE80211_CONF_CHANGE_LISTEN_INTERVAL: the listen interval changed * @IEEE80211_CONF_CHANGE_RADIOTAP: the radiotap flag changed * @IEEE80211_CONF_CHANGE_PS: the PS flag or dynamic PS timeout changed * @IEEE80211_CONF_CHANGE_POWER: the TX power changed * @IEEE80211_CONF_CHANGE_CHANNEL: the channel/channel_type changed * @IEEE80211_CONF_CHANGE_RETRY_LIMITS: retry limits changed + * @IEEE80211_CONF_CHANGE_IDLE: Idle flag changed */ enum ieee80211_conf_changed { IEEE80211_CONF_CHANGE_RADIO_ENABLED = BIT(0), - IEEE80211_CONF_CHANGE_BEACON_INTERVAL = BIT(1), + _IEEE80211_CONF_CHANGE_BEACON_INTERVAL = BIT(1), IEEE80211_CONF_CHANGE_LISTEN_INTERVAL = BIT(2), IEEE80211_CONF_CHANGE_RADIOTAP = BIT(3), IEEE80211_CONF_CHANGE_PS = BIT(4), IEEE80211_CONF_CHANGE_POWER = BIT(5), IEEE80211_CONF_CHANGE_CHANNEL = BIT(6), IEEE80211_CONF_CHANGE_RETRY_LIMITS = BIT(7), + IEEE80211_CONF_CHANGE_IDLE = BIT(8), }; +static inline __deprecated enum ieee80211_conf_changed +__IEEE80211_CONF_CHANGE_BEACON_INTERVAL(void) +{ + return _IEEE80211_CONF_CHANGE_BEACON_INTERVAL; +} +#define IEEE80211_CONF_CHANGE_BEACON_INTERVAL \ + __IEEE80211_CONF_CHANGE_BEACON_INTERVAL() + /** * struct ieee80211_conf - configuration of the device * @@ -559,7 +590,7 @@ enum ieee80211_conf_changed { * @beacon_int: beacon interval (TODO make interface config) * * @listen_interval: listen interval in units of beacon interval - * @max_sleep_interval: the maximum number of beacon intervals to sleep for + * @max_sleep_period: the maximum number of beacon intervals to sleep for * before checking the beacon for a TIM bit (managed mode only); this * value will be only achievable between DTIM frames, the hardware * needs to check for the multicast traffic bit in DTIM beacons. @@ -584,7 +615,7 @@ struct ieee80211_conf { int beacon_int; u32 flags; int power_level, dynamic_ps_timeout; - int max_sleep_interval; + int max_sleep_period; u16 listen_interval; bool radio_enabled; @@ -650,37 +681,6 @@ struct ieee80211_if_init_conf { }; /** - * enum ieee80211_if_conf_change - interface config change flags - * - * @IEEE80211_IFCC_BSSID: The BSSID changed. - * @IEEE80211_IFCC_BEACON: The beacon for this interface changed - * (currently AP and MESH only), use ieee80211_beacon_get(). - * @IEEE80211_IFCC_BEACON_ENABLED: The enable_beacon value changed. - */ -enum ieee80211_if_conf_change { - IEEE80211_IFCC_BSSID = BIT(0), - IEEE80211_IFCC_BEACON = BIT(1), - IEEE80211_IFCC_BEACON_ENABLED = BIT(2), -}; - -/** - * struct ieee80211_if_conf - configuration of an interface - * - * @changed: parameters that have changed, see &enum ieee80211_if_conf_change. - * @bssid: BSSID of the network we are associated to/creating. - * @enable_beacon: Indicates whether beacons can be sent. - * This is valid only for AP/IBSS/MESH modes. - * - * This structure is passed to the config_interface() callback of - * &struct ieee80211_hw. - */ -struct ieee80211_if_conf { - u32 changed; - const u8 *bssid; - bool enable_beacon; -}; - -/** * enum ieee80211_key_alg - key algorithm * @ALG_WEP: WEP40 or WEP104 * @ALG_TKIP: TKIP @@ -1348,10 +1348,6 @@ enum ieee80211_ampdu_mlme_action { * This function should never fail but returns a negative error code * if it does. * - * @config_interface: Handler for configuration requests related to interfaces - * (e.g. BSSID changes.) - * Returns a negative error code which will be seen in userspace. - * * @bss_info_changed: Handler for configuration requests related to BSS * parameters that may vary during BSS's lifespan, and may affect low * level driver (e.g. assoc/disassoc status, erp parameters). @@ -1453,9 +1449,6 @@ struct ieee80211_ops { void (*remove_interface)(struct ieee80211_hw *hw, struct ieee80211_if_init_conf *conf); int (*config)(struct ieee80211_hw *hw, u32 changed); - int (*config_interface)(struct ieee80211_hw *hw, - struct ieee80211_vif *vif, - struct ieee80211_if_conf *conf); void (*bss_info_changed)(struct ieee80211_hw *hw, struct ieee80211_vif *vif, struct ieee80211_bss_conf *info, |