diff options
Diffstat (limited to 'net/dccp/ccids/Kconfig')
| -rw-r--r-- | net/dccp/ccids/Kconfig | 58 |
1 files changed, 56 insertions, 2 deletions
diff --git a/net/dccp/ccids/Kconfig b/net/dccp/ccids/Kconfig index 8533dabfb9f..80f46988769 100644 --- a/net/dccp/ccids/Kconfig +++ b/net/dccp/ccids/Kconfig @@ -28,13 +28,20 @@ config IP_DCCP_CCID2 This text was extracted from RFC 4340 (sec. 10.1), http://www.ietf.org/rfc/rfc4340.txt + To compile this CCID as a module, choose M here: the module will be + called dccp_ccid2. + If in doubt, say M. config IP_DCCP_CCID2_DEBUG - bool "CCID2 debug" + bool "CCID2 debugging messages" depends on IP_DCCP_CCID2 ---help--- - Enable CCID2 debug messages. + Enable CCID2-specific debugging messages. + + When compiling CCID2 as a module, this debugging output can + additionally be toggled by setting the ccid2_debug module + parameter to 0 or 1. If in doubt, say N. @@ -62,10 +69,57 @@ config IP_DCCP_CCID3 This text was extracted from RFC 4340 (sec. 10.2), http://www.ietf.org/rfc/rfc4340.txt + To compile this CCID as a module, choose M here: the module will be + called dccp_ccid3. + If in doubt, say M. config IP_DCCP_TFRC_LIB depends on IP_DCCP_CCID3 def_tristate IP_DCCP_CCID3 +config IP_DCCP_CCID3_DEBUG + bool "CCID3 debugging messages" + depends on IP_DCCP_CCID3 + ---help--- + Enable CCID3-specific debugging messages. + + When compiling CCID3 as a module, this debugging output can + additionally be toggled by setting the ccid3_debug module + parameter to 0 or 1. + + If in doubt, say N. + +config IP_DCCP_CCID3_RTO + int "Use higher bound for nofeedback timer" + default 100 + depends on IP_DCCP_CCID3 && EXPERIMENTAL + ---help--- + Use higher lower bound for nofeedback timer expiration. + + The TFRC nofeedback timer normally expires after the maximum of 4 + RTTs and twice the current send interval (RFC 3448, 4.3). On LANs + with a small RTT this can mean a high processing load and reduced + performance, since then the nofeedback timer is triggered very + frequently. + + This option enables to set a higher lower bound for the nofeedback + value. Values in units of milliseconds can be set here. + + A value of 0 disables this feature by enforcing the value specified + in RFC 3448. The following values have been suggested as bounds for + experimental use: + * 16-20ms to match the typical multimedia inter-frame interval + * 100ms as a reasonable compromise [default] + * 1000ms corresponds to the lower TCP RTO bound (RFC 2988, 2.4) + + The default of 100ms is a compromise between a large value for + efficient DCCP implementations, and a small value to avoid disrupting + the network in times of congestion. + + The purpose of the nofeedback timer is to slow DCCP down when there + is serious network congestion: experimenting with larger values should + therefore not be performed on WANs. + + endmenu |