aboutsummaryrefslogtreecommitdiff
path: root/arch/avr32/mach-at32ap/Makefile
AgeCommit message (Collapse)Author
2008-08-08avr32: Clean up HMATRIX codeHaavard Skinnemoen
Introduce a few helper functions for HMATRIX configuration and clean up the register definitions. Also add definitions for the HMATRIX master and slave IDs on the AT32AP700x chips. Also make the definitions in hmatrix.h available to board code by moving it to <mach/hmatrix.h> Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
2008-07-02avr32: Power Management support ("standby" and "mem" modes)Haavard Skinnemoen
Implement Standby support. In this mode, we'll suspend all drivers, put the SDRAM in self-refresh mode and switch off the HSB bus ("frozen" mode.) Implement Suspend-to-mem support. In this mode, we suspend all drivers, put the SDRAM into self-refresh mode and switch off all internal clocks except the 32 kHz oscillator ("stop" mode.) The lowest-level suspend code runs from a small portion of SRAM allocated at startup time. This gets rid of a small potential race with the SDRAM where we might try to enter self-refresh mode in the middle of an icache burst. We also relocate all interrupt and exception handlers to SRAM during the small window when we enter and exit the low-power modes. We don't need to do any special tricks to start and stop the PLL. The main clock is automatically gated by hardware until the PLL is stable. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
2008-06-28avr32: Rename at32ap.c -> pdc.cHaavard Skinnemoen
The only thing left in at32ap.c is some PDC stuff. Rename the file to reflect what it actually does. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
2008-04-19avr32: Generic clockevents supportDavid Brownell
This combines three patches from David Brownell: * avr32: tclib support * avr32: simplify clocksources * avr32: Turn count/compare into a oneshot clockevent device Register both TC blocks (instead of just the first one) so that the AT32/AT91 tclib code will pick them up (instead of just the avr32-only PIT-style clocksource). Rename the first one and its resources appropriately. More cleanups to the cycle counter clocksource code - Disable all the weak symbol magic; remove the AVR32-only TCB-based clocksource code (source and header). - Mark the __init code properly. - Don't forget to report IRQF_TIMER. - Make the system work properly with this clocksource, by preventing use of the CPU "idle" sleep state in the idle loop when it's used. Package the avr32 count/compare timekeeping support as a oneshot clockevent device, so it supports NO_HZ and high res timers. This means it also supports plugging in other clockevent devices and clocksources. Signed-off-by: David Brownell <dbrownell@users.sourceforge.net> Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
2008-04-19avr32: Move sleep code into mach-at32apHaavard Skinnemoen
Create a new file, pm-at32ap700x.S, in mach-at32ap and move the CPU idle sleep code there. Make it possible to disable the sleep code. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
2008-01-25[AVR32] Add support for AT32AP7001 and AT32AP7002Haavard Skinnemoen
These are derivatives of the AT32AP7000 chip, which means that most of the code stays the same. Rename a few files, functions, definitions and config symbols to reflect that they apply to all AP700x chips, and exclude some platform devices from chips where they aren't present. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
2007-07-18[AVR32] CPU frequency scaling for AT32APHans-Christian Egtvedt
This patch enables CPU frequency scaling for AT32AP devices. This will enable the CPU to scale between the speed of the high speed bus and the master clock and thus save some power. The patch also adds a parent to cpu_clk and a cpu_clk_set_rate to enable changing the CPU clock divider in a sane way. The driver does not check if the given rate is 0, thus resulting in a div by 0. I think this check should be go into the clk_set_rate framework, and not here. Tested on AT32AP7000/ATSTK1000. Hardware documentation can be found in the AT32AP7000 datasheet. Signed-off-by: Hans-Christian Egtvedt <hcegtvedt@atmel.com> Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
2007-04-27[AVR32] Change system timer from count-compare to Timer/Counter 0Hans-Christian Egtvedt
Due to limitation of the count-compare system timer (not able to count when CPU is in sleep), the system timer had to be changed to use a peripheral timer/counter. The old COUNT-COMPARE code is still present in time.c as weak functions. The new timer is added to the architecture directory. This patch sets up TC0 as system timer The new timer has been tested on AT32AP7000/ATSTK1000 at 100 Hz, 250 Hz, 300 Hz and 1000 Hz. For more details about the timer/counter see the datasheet for AT32AP700x available at http://www.atmel.com/dyn/products/product_card.asp?part_id=3903 Signed-off-by: Hans-Christian Egtvedt <hcegtvedt@atmel.com> Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
2007-02-09[AVR32] GPIO API implementationHaavard Skinnemoen
Arch-neutral GPIO calls for AVR32. GPIO IRQ support written by David Brownell. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
2006-09-26[PATCH] AVR32 MTD: Static Memory Controller driverHaavard Skinnemoen
This patchset adds the necessary drivers and infrastructure to access the external flash on the ATSTK1000 board through the MTD subsystem. With this stuff in place, it will be possible to use a jffs2 filesystem stored in the external flash as a root filesystem. It might also be possible to update the boot loader if you drop the write protection of partition 0. As suggested by David Woodhouse, I reworked the patches to use the physmap driver instead of introducing a separate mapping driver for the ATSTK1000. I've also cleaned up the hsmc header by removing useless comments and converting spaces to tabs (my headerfile generator needs some work.) Unfortunately, I couldn't unlock the flash in fixup_use_atmel_lock because the erase regions hadn't been set up yet, so I had to do it from cfi_amdstd_setup instead. This patch: This adds a simple API for configuring the static memory controller along with an implementation for the Atmel HSMC. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com> Cc: David Woodhouse <dwmw2@infradead.org> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
2006-09-26[PATCH] avr32 architectureHaavard Skinnemoen
This adds support for the Atmel AVR32 architecture as well as the AT32AP7000 CPU and the AT32STK1000 development board. AVR32 is a new high-performance 32-bit RISC microprocessor core, designed for cost-sensitive embedded applications, with particular emphasis on low power consumption and high code density. The AVR32 architecture is not binary compatible with earlier 8-bit AVR architectures. The AVR32 architecture, including the instruction set, is described by the AVR32 Architecture Manual, available from http://www.atmel.com/dyn/resources/prod_documents/doc32000.pdf The Atmel AT32AP7000 is the first CPU implementing the AVR32 architecture. It features a 7-stage pipeline, 16KB instruction and data caches and a full Memory Management Unit. It also comes with a large set of integrated peripherals, many of which are shared with the AT91 ARM-based controllers from Atmel. Full data sheet is available from http://www.atmel.com/dyn/resources/prod_documents/doc32003.pdf while the CPU core implementation including caches and MMU is documented by the AVR32 AP Technical Reference, available from http://www.atmel.com/dyn/resources/prod_documents/doc32001.pdf Information about the AT32STK1000 development board can be found at http://www.atmel.com/dyn/products/tools_card.asp?tool_id=3918 including a BSP CD image with an earlier version of this patch, development tools (binaries and source/patches) and a root filesystem image suitable for booting from SD card. Alternatively, there's a preliminary "getting started" guide available at http://avr32linux.org/twiki/bin/view/Main/GettingStarted which provides links to the sources and patches you will need in order to set up a cross-compiling environment for avr32-linux. This patch, as well as the other patches included with the BSP and the toolchain patches, is actively supported by Atmel Corporation. [dmccr@us.ibm.com: Fix more pxx_page macro locations] [bunk@stusta.de: fix `make defconfig'] Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com> Signed-off-by: Adrian Bunk <bunk@stusta.de> Signed-off-by: Dave McCracken <dmccr@us.ibm.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>