aboutsummaryrefslogtreecommitdiff
path: root/drivers/net/e1000e/ethtool.c
AgeCommit message (Collapse)Author
2008-05-06e1000e: don't return half-read eeprom on errorKok, Auke
On a read error, e1000e might have returned uninitialized block of eeprom data back to userspace. The convention is that 0xff is "empty", so mark the entire eeprom as empty in case of an error. Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
2008-05-06e1000e: Add support for BM PHYs on ICH9Bruce Allan
This patch adds support for the BM PHY, a new PHY model being used on ICH9-based implementations. This new PHY exposes issues in the ICH9 silicon when receiving jumbo frames large enough to use more than a certain part of the Rx FIFO, and this unfortunately breaks packet split jumbo receives. For this reason we re-introduce (for affected adapters only) the jumbo single-skb receive routine back so that people who do wish to use jumbo frames on these ich9 platforms can do so. Part of this problem has to do with CPU sleep states and to make sure that all the wake up timings are correctly we force them with the recently merged pm_qos infrastructure written by Mark Gross. (See http://lkml.org/lkml/2007/10/4/400). To make code read a bit easier we introduce a _IS_ICH flag so that we don't need to do mac type checks over the code. Signed-off-by: Bruce Allan <bruce.w.allan@intel.com> Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
2008-04-25e1000e: Add interrupt moderation run-time ethtool interfaceAuke Kok
The ethtool -c / -C interface can now be used to modify the irq moderation algorithm. This change does not require an adapter reset and can thus be used at all times. The adapter only supports changing/reading rx-usecs which has special values for 0, 1 and 3: 0 - no irq moderation whatsoever 1 - normal moderation favoring regular mixed traffic (default) 3 - best attempt at low latency possible at cost of CPU For values between 10 and 10000 the rx-usecs defines "the minimum time between successive irqs" in usec, unlike the module parameter. Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
2008-04-25e1000e: cleanup several stats issuesBruce Allan
Several stats registers are completely unused and we just waste pci bus time reading them. We also omit using the high 32 bits of the GORC/ GOTC counters. We can just read clear them and only read the low registers. Mii-tool can also break es2lan if it executes a MII PHY register ioctl while the device is in autonegotiation. Unfortunately it seems that several applications and installations still perform this ioctl call periodically and especially in this crucial startup time. We can fool the ioctl by providing fail safe information that mimics the "down" link state and only perform the dangerous PHY reads once after link comes up to fill in the real values. As long as link stays up the information will not change. Signed-off-by: Bruce Allan <bruce.w.allan@intel.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com> Signed-off-by: Jesse Brandeburg <jesse.brandeburg@intel.com> Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
2008-04-16e1000e: reformat register test code, fix some minor initializationBruce Allan
The register tests should be run with all the proper flags enabled to maximize the test coverage code and make sure we are as close as we can get to testing regular traffic. Reformat the code for readability. Minor cleanups in the descriptor ring setup. Signed-off-by: Bruce Allan <bruce.w.allan@intel.com> Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
2008-03-28e1000e: reorganize PHY and flow control interfaceJeff Kirsher
This reorganization moves the PHY status into a separate struct. Flow Control setup is moved into this struct as well and frame size away from here into the adapter struct where its inly use is. The post-link-up code is now a separate function and moved out of the watchdog function itself. This allows us to track the es2lan restart issue a bit easier. Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com> Signed-off-by: Bruce Allan <bruce.w.allan@intel.com> Signed-off-by: Jesse Brandeburg <jesse.brandeburg@intel.com> Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org>
2008-03-28e1000e: reformat comment blocks, cosmetic changes onlyBruce Allan
Adjusting the comment blocks here to be code-style compliant. no code changes. Changed some copyright dates to 2008. Indentation fixes. Signed-off-by: Bruce Allan <bruce.w.allan@intel.com> Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org>
2008-02-03e1000e: make a function staticAdrian Bunk
This patch makes the needlessly global reg_pattern_test_array() static. Signed-off-by: Adrian Bunk <bunk@kernel.org> Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org> Signed-off-by: David S. Miller <davem@davemloft.net>
2008-02-03e1000e: add new wakeup cababilitiesMitch Williams
Ethtool supports wake-on-ARP and wake-on-link, and so does the hardware supported by e1000e. This patch just introduces the two. Signed-off-by: Mitch Williams <mitch.a.williams@intel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org> Signed-off-by: David S. Miller <davem@davemloft.net>
2008-01-28[E1000E]: convert register test macros to functionsJoe Perches
Add functions for reg_pattern_test and reg_set_and check Changed macros to use these functions Compiled x86, untested Size decreased ~2K old: $ size drivers/net/e1000e/ethtool.o text data bss dec hex filename 14461 0 0 14461 387d drivers/net/e1000e/ethtool.o new: $ size drivers/net/e1000e/ethtool.o text data bss dec hex filename 12498 0 0 12498 30d2 drivers/net/e1000e/ethtool.o Signed-off-by: Joe Perches <joe@perches.com> Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2008-01-28netdev: ARRAY_SIZE() cleanupsAlejandro Martinez Ruiz
Convert array size calculations to use ARRAY_SIZE(). Signed-off-by: Alejandro Martinez Ruiz <alex@flawedcode.org> Signed-off-by: Jeff Garzik <jeff@garzik.org>
2008-01-28netdev: use ARRAY_SIZE() instead of sizeof(array) / ETH_GSTRING_LENAlejandro Martinez Ruiz
Using ARRAY_SIZE() on arrays of the form array[][K] makes it unnecessary to know the value of K when checking its size. Signed-off-by: Alejandro Martinez Ruiz <alex@flawedcode.org> Signed-off-by: Jeff Garzik <jeff@garzik.org>
2007-12-07e1000: fix memcpy in e1000_get_stringsRoel Kluin
drivers/net/e1000/e1000_ethtool.c:113: #define E1000_TEST_LEN sizeof(e1000_gstrings_test) / ETH_GSTRING_LEN drivers/net/e1000e/ethtool.c:106: #define E1000_TEST_LEN sizeof(e1000_gstrings_test) / ETH_GSTRING_LEN E1000_TEST_LEN*ETH_GSTRING_LEN will expand to sizeof(e1000_gstrings_test) / (ETH_GSTRING_LEN * ETH_GSTRING_LEN) A lack of parentheses around defines causes unexpected results due to operator precedences. Signed-off-by: Roel Kluin <12o3l@tiscali.nl> Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org>
2007-10-30e1000e: fix sparse warningsStephen Hemminger
Fix sparse warnings from e1000e driver in net-2.6.24. Added a sparse fix for module param arrays which can have int values but only the array index needs to be unsigned. --Auke Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org> Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org>
2007-10-16e1000e: don't poke PHY registers to retreive link statusAuke Kok
Apparently poking the link status registers when autonegotiation is running on the PHY might botch the PHY link on 80003es2lan devices. While this is a very rare condition we can completely avoid it alltogether by just using the MAC link bits to provide the proper information to ethtool. Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org>
2007-10-16e1000e: fix error checksAdrian Bunk
Spotted by the Coverity checker. Signed-off-by: Adrian Bunk <bunk@kernel.org> Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org>
2007-10-10e1000e: restore flow control settings properlyAuke Kok
After a cable unplug the forced flow control settings were lost accidentally and the flow control settings fell back to the default EEPROM determined values. This breaks for people who want to run without fc enabled - after a cable reset the driver would refuse to run with fc disabled. Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org>
2007-10-10e1000e: Fix ethtool register test codeAuke Kok
A merge/cleanup code accidentally dropped 8254x code in and removed 8257x code here. Undo this mistake and use the pci-e relevant register test similar as to what is in e1000. Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org>
2007-10-10[netdrvr] Stop using legacy hooks ->self_test_count, ->get_stats_countJeff Garzik
These have been superceded by the new ->get_sset_count() hook. Signed-off-by: Jeff Garzik <jeff@garzik.org> Signed-off-by: David S. Miller <davem@davemloft.net>
2007-10-10[E1000E]: New pci-express e1000 driver (currently for ICH9 devices only)Auke Kok
This driver implements support for the ICH9 on-board LAN ethernet device. The device is similar to ICH8. The driver encompasses code to support 82571/2/3, es2lan and ICH8 devices as well, but those device IDs are disabled and will be "lifted" from the e1000 driver over one at a time once this driver receives some more live time. Changes to the last snapshot posted are exclusively in the internal hardware API organization. Many thanks to Jeff Garzik for jumping in and getting this organized with a keen eye on the future layout. [ Integrated napi_struct patch from Auke as well... -DaveM ] Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org> Signed-off-by: David S. Miller <davem@davemloft.net>
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-12 22:52:10 +0000