Age | Commit message (Collapse) | Author |
|
Removed invalid BUG() - the driver should handle the error case properly
rather than issuing BUG().
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Clean up the pci id table using PCI_DEVICE() macro.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Signed-off-by: Ahmet İnan <ainan <at> mathematik.uni-freiburg.de>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Some laptops have a internal analog microphone that is not setup by the BIOS.
Signed-off-by: Matthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Added PCI_QUIRKS for laptop that have the 92HDxxx family of codecs.
Signed-off-by: Matthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
STAC_DELL_BIOS quirks were setting the association value wrong
for port 0x0f, which prevented it from being included in hp_outs[].
Signed-off-by: Matthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Fix issue on STAC927x codecs that first DAC was getting powered down
even if was being used.
Signed-off-by: Matthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Signed-off-by: Jarkko Nikula <jarkko.nikula@nokia.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Added the missing declarations for module parameters.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Signed-off-by: Cedric Bregardis <cedric.bregardis@free.fr>
Signed-off-by: Jean-Christian Hassler <jhassler@free.fr>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
When the device has only one input source, it makes no sense to have
multiple capture streams.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Initialize the capture source properly for auto model.
It's especially important for cases that only mic is detected.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Added the beep volume control to ALC268 codec support code.
Since the codec doesn't return the correct AMP caps, we need to override
the value.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Fixed ALC662 recording issue.
Signed-off-by: Kailang Yang <kailang@realtek.com.tw>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Clean up the code to define playback/capture streams.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Added master volume and switch controls for ca0106 using vmaster.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Use a private array for TLV entries of virtual master controls instead
of (supposed) static array. This cleans up the existing codes.
Also, now vmaster assumes the simple dB-range TLV that is the only type
it can handle.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Move the codes for virtual master controls to sound core part so that
not only hda-intel drivers can use it.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Added the support of 8 channel sound for codecs that are known to work.
So far, only ALC850 is marked as a 8ch-support codec.
This fix is a modified version of the patch on ALSA BTS#2097 by
Martin Ellis:
https://bugtrack.alsa-project.org/alsa-bug/view.php?id=2097
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
This patch adds __devinit to the functions used when probing. Will also reduce
the memory footprint a bit if CONFIG_HOTPLUG is not enabled.
Signed-off-by: Hans-Christian Egtvedt <hcegtvedt@atmel.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Add ASoC support for the TI Davinci SoC and the Davicni-EVM reference board.
It includes:
- ASoC Davinci DMA driver
- ASoC Davinci I2S (Davinci McBSP module based) driver
- ASoC Davinci-EVM reference board
Signed-off-by: Vladimir Barinov <vbarinov@ru.mvista.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Added the new model mobile for AD1884A and compatible codecs.
It's a reduced version of model=laptop.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Added the support of new AD codecs: AD1883, AD1884A, AD1984A and AD1984B.
These are almost compatible except for additional digital pins, etc.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
This patch adds an ASoC driver for the WM9713 AC97 codec.
Signed-off-by: Liam Girdwood <liam.girdwood@wolfsonmicro.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
ALC262 must have capsrc_nids defined as well as in ALC882.
Also, add a NULL check in alc882_mux_enum_put to avoid Oops.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
This patch is to add R7xx HDMI audio support.
Signed-off-by: Libin Yang <Libin.yang@amd.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
The last patch for fixing the auto-config pin setting breaks the resume
due to a wrong use of snd_hda_codec_amp_stereo(). The code in the init
hook shouldn't touch the amp cache.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Added more known names to the vendor id list.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Added a new mixer switch to enable/disable the sharing of the default
PCM stream with analog and SPDIF outputs. When "IEC958 Default PCM"
switch is on, the PCM stream is routed both to analog and SPDIF outputs.
This is the behavior in the earlier version.
Turning this switch off has a merit for some codecs, though. Some codec
chips don't support 24bit formats for SPDIF but only for analog outputs.
In this case, you can use 24bit format by disabling this switch.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
This patch fixes some bugs in the auto-configurator of Realtek codecs:
- add missing pin set-up for speaker pins
- fix the speaker auto-mute function not to conflict with the existing
"Speaker" mixer switch
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
In some cases, the BIOS sets up only the HP pins with different assoc
and sequence numbers, e.g. on FSC Esprimo with ALC262.
This patch adds a fix-up for such a case. When multiple HPs are defined
and no line-outs is found, the configurator tries to re-assign some pins
from HP list to line-out, judging from the sequence number.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Implemented the auto-mic jack sensing for Samsung laptops with AD1986A
codec chip (model=laptop-eapd).
The hardware uses pin 0x1d and 0x1f for the internal and external
mics, respectively.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Clean up the codes of the capture source selection for Realtek codecs.
Now using common helper functions with the new capsrc_nids field.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Reprogram the speaker-pin setting at each HP pin plug to make sure
the spekaer auto-muting on AD1981HD hp model.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Fixed some issues with ALC880 F1734 model
- fix capture via mic
- enable volume-wheel control
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
A simple patch for listing AK4114 regs in proc.
Signed-off-by: Pavel Hofman <dustin@seznam.cz>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
I've just noticed that there are a handful of duplicate controls in the
ALC268 test model mixer. This patch (against alsa-driver 1.0.16) removes
them.
Signed-off-by: Jonathan Woithe <jwoithe@physics.adelaide.edu.au>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Give better names to the new HDMI transmitter chips.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Forgot to get rid of the obsolete fragsize field from a debug print.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
See ALSA bug#3327 for more details. Experimental.
Also fix support for M-Audio Delta 1010E - subdevice check.
Signed-off-by: Jaroslav Kysela <perex@perex.cz>
|
|
For more details, see ALSA bug#3327 .
Signed-off-by: Jaroslav Kysela <perex@perex.cz>
|
|
The HD-audio hardware usually supports 64bit address for DMA and other
buffers. The patch enables the feature if supported.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Use SG buffers for the HD-audio instead of linear buffers.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
On several laptops that have STAC9228 codecs have unused DACs,
this powers them down to a D3 state.
Signed-off-by: Matthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Fixes the problems with Midi In on Hoontech/STA dsp24 cards, for example with
DSP2000 box, without restricting the box configurations available. Also adds
mpu_401 name strings.
Signed-off-by: Alan Horstmann <gineera@aspect135.co.uk>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Added the ID for an unknown HDMI codec chip on Jetway J9F2.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
In the current scheme, PCM device numbers are assigned incrementally
in the order of codecs. This causes problems when the codec number
is irregular, e.g. codec #0 for HDMI and codec #1 for analog. Then
the HDMI becomes the first PCM, which is picked up as the default
output device. Unfortuantely this doesn't work well with normal
setups.
This patch introduced the fixed device numbers for the PCM types,
namely, analog, SPDIF, HDMI and modem. The PCM devices are assigned
according to the corresponding PCM type. After this patch, HDMI will
be always assigned to PCM #3, SPDIF to PCM #1, and the first analog
to PCM #0, etc.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Added more fallbacks to OSS PHONEOUT mixer mapping. This corresponds
to the speaker output in general, so now "Mono" and "Speaker" are
assigned.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Added the missing GPIO setup for the AK5385A ADC codec on Audiophile192.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Fixed and enabled the support of AK4114 chip on Audiophile192.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|