From 1da177e4c3f41524e886b7f1b8a0c1fc7321cac2 Mon Sep 17 00:00:00 2001 From: Linus Torvalds Date: Sat, 16 Apr 2005 15:20:36 -0700 Subject: Linux-2.6.12-rc2 Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip! --- Documentation/networking/ewrk3.txt | 46 ++++++++++++++++++++++++++++++++++++++ 1 file changed, 46 insertions(+) create mode 100644 Documentation/networking/ewrk3.txt (limited to 'Documentation/networking/ewrk3.txt') diff --git a/Documentation/networking/ewrk3.txt b/Documentation/networking/ewrk3.txt new file mode 100644 index 00000000000..90e9e5f16e6 --- /dev/null +++ b/Documentation/networking/ewrk3.txt @@ -0,0 +1,46 @@ +The EtherWORKS 3 driver in this distribution is designed to work with all +kernels > 1.1.33 (approx) and includes tools in the 'ewrk3tools' +subdirectory to allow set up of the card, similar to the MSDOS +'NICSETUP.EXE' tools provided on the DOS drivers disk (type 'make' in that +subdirectory to make the tools). + +The supported cards are DE203, DE204 and DE205. All other cards are NOT +supported - refer to 'depca.c' for running the LANCE based network cards and +'de4x5.c' for the DIGITAL Semiconductor PCI chip based adapters from +Digital. + +The ability to load this driver as a loadable module has been included and +used extensively during the driver development (to save those long reboot +sequences). To utilise this ability, you have to do 8 things: + + 0) have a copy of the loadable modules code installed on your system. + 1) copy ewrk3.c from the /linux/drivers/net directory to your favourite + temporary directory. + 2) edit the source code near line 1898 to reflect the I/O address and + IRQ you're using. + 3) compile ewrk3.c, but include -DMODULE in the command line to ensure + that the correct bits are compiled (see end of source code). + 4) if you are wanting to add a new card, goto 5. Otherwise, recompile a + kernel with the ewrk3 configuration turned off and reboot. + 5) insmod ewrk3.o + [Alan Cox: Changed this so you can insmod ewrk3.o irq=x io=y] + [Adam Kropelin: Multiple cards now supported by irq=x1,x2 io=y1,y2] + 6) run the net startup bits for your new eth?? interface manually + (usually /etc/rc.inet[12] at boot time). + 7) enjoy! + + Note that autoprobing is not allowed in loadable modules - the system is + already up and running and you're messing with interrupts. + + To unload a module, turn off the associated interface + 'ifconfig eth?? down' then 'rmmod ewrk3'. + +The performance we've achieved so far has been measured through the 'ttcp' +tool at 975kB/s. This measures the total TCP stack performance which +includes the card, so don't expect to get much nearer the 1.25MB/s +theoretical Ethernet rate. + + +Enjoy! + +Dave -- cgit v1.2.3