From cf40a310a7aaf1944eea3e01e9c120b31850c3b6 Mon Sep 17 00:00:00 2001 From: Rene Herman Date: Tue, 28 Mar 2006 12:38:20 +0200 Subject: [ALSA] AdLib FM card driver Attached you'll find an ALSA driver for AdLib FM cards. An AdLib card is just an OPL2, which was already supported by sound/drivers/opl3, so only very minimal bus-glue is needed. The patch applies cleanly to both 2.6.16 and 2.6.16-mm1. The driver has been tested with an actual ancient 8-bit ISA AdLib card and works fine. It also works fine for an OPL3 {,emulation} as still found on many ISA soundcards but given that AdLib cards don't have their own mixer, upping the volume from 0 might be a problem without the card driver already loaded and driving the OPL3. Signed-off-by: Takashi Iwai --- Documentation/sound/alsa/ALSA-Configuration.txt | 28 +++++++++++++++++++++++++ 1 file changed, 28 insertions(+) (limited to 'Documentation/sound') diff --git a/Documentation/sound/alsa/ALSA-Configuration.txt b/Documentation/sound/alsa/ALSA-Configuration.txt index a8c3c7e847c..0ee2c7dfc48 100644 --- a/Documentation/sound/alsa/ALSA-Configuration.txt +++ b/Documentation/sound/alsa/ALSA-Configuration.txt @@ -120,6 +120,34 @@ Prior to version 0.9.0rc4 options had a 'snd_' prefix. This was removed. enable - enable card - Default: enabled, for PCI and ISA PnP cards + Module snd-adlib + ---------------- + + Module for AdLib FM cards. + + port - port # for OPL chip + + This module supports multiple cards. It does not support autoprobe, so + the port must be specified. For actual AdLib FM cards it will be 0x388. + Note that this card does not have PCM support and no mixer; only FM + synthesis. + + Make sure you have "sbiload" from the alsa-tools package available and, + after loading the module, find out the assigned ALSA sequencer port + number through "sbiload -l". Example output: + + Port Client name Port name + 64:0 OPL2 FM synth OPL2 FM Port + + Load the std.sb and drums.sb patches also supplied by sbiload: + + sbiload -p 64:0 std.sb drums.sb + + If you use this driver to drive an OPL3, you can use std.o3 and drums.o3 + instead. To have the card produce sound, use aplaymidi from alsa-utils: + + aplaymidi -p 64:0 foo.mid + Module snd-ad1816a ------------------ -- cgit v1.2.3