From 6395bee7e92bf34e95dc67c1da5acc30e8b98244 Mon Sep 17 00:00:00 2001 From: David Brownell Date: Tue, 8 Apr 2008 17:41:58 -0700 Subject: spi: documentation tweaks Update SPI documentation to clarify some areas of recent confusion: clock polarity takes effect when chipselect goes active; and zero length buffers are OK in certain cases. Signed-off-by: David Brownell Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds --- Documentation/spi/spi-summary | 15 ++++++++++++++- 1 file changed, 14 insertions(+), 1 deletion(-) (limited to 'Documentation/spi') diff --git a/Documentation/spi/spi-summary b/Documentation/spi/spi-summary index 8861e47e5a2..6d5f18143c5 100644 --- a/Documentation/spi/spi-summary +++ b/Documentation/spi/spi-summary @@ -116,6 +116,13 @@ low order bit. So when a chip's timing diagram shows the clock starting low (CPOL=0) and data stabilized for sampling during the trailing clock edge (CPHA=1), that's SPI mode 1. +Note that the clock mode is relevant as soon as the chipselect goes +active. So the master must set the clock to inactive before selecting +a slave, and the slave can tell the chosen polarity by sampling the +clock level when its select line goes active. That's why many devices +support for example both modes 0 and 3: they don't care about polarity, +and alway clock data in/out on rising clock edges. + How do these driver programming interfaces work? ------------------------------------------------ @@ -379,8 +386,14 @@ any more such messages. + when bidirectional reads and writes start ... by how its sequence of spi_transfer requests is arranged; + + which I/O buffers are used ... each spi_transfer wraps a + buffer for each transfer direction, supporting full duplex + (two pointers, maybe the same one in both cases) and half + duplex (one pointer is NULL) transfers; + + optionally defining short delays after transfers ... using - the spi_transfer.delay_usecs setting; + the spi_transfer.delay_usecs setting (this delay can be the + only protocol effect, if the buffer length is zero); + whether the chipselect becomes inactive after a transfer and any delay ... by using the spi_transfer.cs_change flag; -- cgit v1.2.3