From 4bbf39c29bc3409d6454faf0dfa1b3b0aa2ac2af Mon Sep 17 00:00:00 2001 From: Ingo Molnar Date: Fri, 17 Feb 2006 13:52:44 -0800 Subject: [PATCH] Introduce CONFIG_DEFAULT_MIGRATION_COST Heiko Carstens wrote: The boot sequence on s390 sometimes takes ages and we spend a very long time (up to one or two minutes) in calibrate_migration_costs. The time spent there differs from boot to boot. Also the calculated costs differ a lot. I've seen differences by up to a factor of 15 (yes, factor not percent). Also I doubt that making these measurements make much sense on a completely virtualized architecture where you cannot tell how much cpu time you will get anyway. So introduce the CONFIG_DEFAULT_MIGRATION_COST method for an architecture to set the scheduler migration costs. This turns off automatic detection of migration costs. Makes sense on virtual platforms, where migration costs are hard to measure accurately. Signed-off-by: Ingo Molnar Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds --- arch/s390/Kconfig | 4 ++++ 1 file changed, 4 insertions(+) (limited to 'arch') diff --git a/arch/s390/Kconfig b/arch/s390/Kconfig index b66602ad7b3..b7ca5bf9acf 100644 --- a/arch/s390/Kconfig +++ b/arch/s390/Kconfig @@ -80,6 +80,10 @@ config HOTPLUG_CPU can be controlled through /sys/devices/system/cpu/cpu#. Say N if you want to disable CPU hotplug. +config DEFAULT_MIGRATION_COST + int + default "1000000" + config MATHEMU bool "IEEE FPU emulation" depends on MARCH_G5 -- cgit v1.2.3