From c4f9f16b309b65f9f578ec4ba78b3efa106cf65d Mon Sep 17 00:00:00 2001 From: Vasanthakumar Thiagarajan Date: Fri, 12 Jun 2009 10:55:55 +0530 Subject: ath9k: Make sure we configure a non-zero beacon interval This patch moves the sanity check on beacon interval which was done only for mesh mode to all operating modes just to be safe. Signed-off-by: Vasanthakumar Thiagarajan Signed-off-by: John W. Linville --- drivers/net/wireless/ath/ath9k/beacon.c | 15 ++++++++------- 1 file changed, 8 insertions(+), 7 deletions(-) (limited to 'drivers') diff --git a/drivers/net/wireless/ath/ath9k/beacon.c b/drivers/net/wireless/ath/ath9k/beacon.c index 3639a2e6987..45c4ea57616 100644 --- a/drivers/net/wireless/ath/ath9k/beacon.c +++ b/drivers/net/wireless/ath/ath9k/beacon.c @@ -674,13 +674,6 @@ static void ath_beacon_config_adhoc(struct ath_softc *sc, intval = conf->beacon_interval & ATH9K_BEACON_PERIOD; - /* - * It looks like mac80211 may end up using beacon interval of zero in - * some cases (at least for mesh point). Avoid getting into an - * infinite loop by using a bit safer value instead.. - */ - if (intval == 0) - intval = 100; /* Pull nexttbtt forward to reflect the current TSF */ @@ -745,6 +738,14 @@ void ath_beacon_config(struct ath_softc *sc, struct ieee80211_vif *vif) iftype = sc->sc_ah->opmode; } + /* + * It looks like mac80211 may end up using beacon interval of zero in + * some cases (at least for mesh point). Avoid getting into an + * infinite loop by using a bit safer value instead. To be safe, + * do sanity check on beacon interval for all operating modes. + */ + if (cur_conf->beacon_interval == 0) + cur_conf->beacon_interval = 100; switch (iftype) { case NL80211_IFTYPE_AP: -- cgit v1.2.3