/* * arch/arm/mach-ixp4xx/ixdp425-setup.c * * IXDP425/IXCDP1100 board-setup * * Copyright (C) 2003-2005 MontaVista Software, Inc. * * Author: Deepak Saxena <dsaxena@plexity.net> */ #include <linux/kernel.h> #include <linux/init.h> #include <linux/device.h> #include <linux/serial.h> #include <linux/tty.h> #include <linux/serial_8250.h> #include <linux/slab.h> #include <linux/i2c-gpio.h> #include <linux/io.h> #include <linux/mtd/mtd.h> #include <linux/mtd/nand.h> #include <linux/mtd/partitions.h> #include <asm/types.h> #include <asm/setup.h> #include <asm/memory.h> #include <asm/hardware.h> #include <asm/mach-types.h> #include <asm/irq.h> #include <asm/mach/arch.h> #include <asm/mach/flash.h> #include <asm/delay.h> static struct flash_platform_data ixdp425_flash_data = { .map_name = "cfi_probe", .width = 2, }; static struct resource ixdp425_flash_resource = { .flags = IORESOURCE_MEM, }; static struct platform_device ixdp425_flash = { .name = "IXP4XX-Flash", .id = 0, .dev = { .platform_data = &ixdp425_flash_data, }, .num_resources = 1, .resource = &ixdp425_flash_resource, }; #if defined(CONFIG_MTD_NAND_PLATFORM) || \ defined(CONFIG_MTD_NAND_PLATFORM_MODULE) #ifdef CONFIG_MTD_PARTITIONS const char *part_probes[] = { "cmdlinepart", NULL }; static struct mtd_partition ixdp425_partitions[] = { { .name = "ixp400 NAND FS 0", .offset = 0, .size = SZ_8M }, { .name = "ixp400 NAND FS 1", .offset = MTDPART_OFS_APPEND, .size = MTDPART_SIZ_FULL }, }; #endif static void ixdp425_flash_nand_cmd_ctrl(struct mtd_info *mtd, int cmd, unsigned int ctrl) { struct nand_chip *this = mtd->priv; int offset = (int)this->priv; if (ctrl & NAND_CTRL_CHANGE) { if (ctrl & NAND_NCE) { gpio_line_set(IXDP425_NAND_NCE_PIN, IXP4XX_GPIO_LOW); udelay(5); } else gpio_line_set(IXDP425_NAND_NCE_PIN, IXP4XX_GPIO_HIGH); offset = (ctrl & NAND_CLE) ? IXDP425_NAND_CMD_BYTE : 0; offset |= (ctrl & NAND_ALE) ? IXDP425_NAND_ADDR_BYTE : 0; this->priv = (void *)offset; } if (cmd != NAND_CMD_NONE) writeb(cmd, this->IO_ADDR_W + offset); } static struct platform_nand_data ixdp425_flash_nand_data = { .chip = { .chip_delay = 30, .options = NAND_NO_AUTOINCR, #ifdef CONFIG_MTD_PARTITIONS .part_probe_types = part_probes, .partitions = ixdp425_partitions, .nr_partitions = ARRAY_SIZE(ixdp425_partitions), #endif }, .ctrl = { .cmd_ctrl = ixdp425_flash_nand_cmd_ctrl } }; static struct resource ixdp425_flash_nand_resource = { .flags = IORESOURCE_MEM, }; static struct platform_device ixdp425_flash_nand = { .name = "gen_nand", .id = -1, .dev = { .platform_data = &ixdp425_flash_nand_data, }, .num_resources = 1, .resource = &ixdp425_flash_nand_resource, }; #endif /* CONFIG_MTD_NAND_PLATFORM */ static struct i2c_gpio_platform_data ixdp425_i2c_gpio_data = { .sda_pin = IXDP425_SDA_PIN, .scl_pin = IXDP425_SCL_PIN, }; static struct platform_device ixdp425_i2c_gpio = { .name = "i2c-gpio", .id = 0, .dev = { .platform_data = &ixdp425_i2c_gpio_data, }, }; static struct resource ixdp425_uart_resources[] = { { .start = IXP4XX_UART1_BASE_PHYS, .end = IXP4XX_UART1_BASE_PHYS + 0x0fff, .flags = IORESOURCE_MEM }, { .start = IXP4XX_UART2_BASE_PHYS, .end = IXP4XX_UART2_BASE_PHYS + 0x0fff, .flags = IORESOURCE_MEM } }; static struct plat_serial8250_port ixdp425_uart_data[] = { { .mapbase = IXP4XX_UART1_BASE_PHYS, .membase = (char *)IXP4XX_UART1_BASE_VIRT + REG_OFFSET, .irq = IRQ_IXP4XX_UART1, .flags = UPF_BOOT_AUTOCONF | UPF_SKIP_TEST, .iotype = UPIO_MEM, .regshift = 2, .uartclk = IXP4XX_UART_XTAL, }, { .mapbase = IXP4XX_UART2_BASE_PHYS, .membase = (char *)IXP4XX_UART2_BASE_VIRT + REG_OFFSET, .irq = IRQ_IXP4XX_UART2, .flags = UPF_BOOT_AUTOCONF | UPF_SKIP_TEST, .iotype = UPIO_MEM, .regshift = 2, .uartclk = IXP4XX_UART_XTAL, }, { }, }; static struct platform_device ixdp425_uart = { .name = "serial8250", .id = PLAT8250_DEV_PLATFORM, .dev.platform_data = ixdp425_uart_data, .num_resources = 2, .resource = ixdp425_uart_resources }; /* Built-in 10/100 Ethernet MAC interfaces */ static struct eth_plat_info ixdp425_plat_eth[] = { { .phy = 0, .rxq = 3, .txreadyq = 20, }, { .phy = 1, .rxq = 4, .txreadyq = 21, } }; static struct platform_device ixdp425_eth[] = { { .name = "ixp4xx_eth", .id = IXP4XX_ETH_NPEB, .dev.platform_data = ixdp425_plat_eth, }, { .name = "ixp4xx_eth", .id = IXP4XX_ETH_NPEC, .dev.platform_data = ixdp425_plat_eth + 1, } }; static struct platform_device *ixdp425_devices[] __initdata = { &ixdp425_i2c_gpio, &ixdp425_flash, #if defined(CONFIG_MTD_NAND_PLATFORM) || \ defined(CONFIG_MTD_NAND_PLATFORM_MODULE) &ixdp425_flash_nand, #endif &ixdp425_uart, &ixdp425_eth[0], &ixdp425_eth[1], }; static void __init ixdp425_init(void) { ixp4xx_sys_init(); ixdp425_flash_resource.start = IXP4XX_EXP_BUS_BASE(0); ixdp425_flash_resource.end = IXP4XX_EXP_BUS_BASE(0) + ixp4xx_exp_bus_size - 1; #if defined(CONFIG_MTD_NAND_PLATFORM) || \ defined(CONFIG_MTD_NAND_PLATFORM_MODULE) ixdp425_flash_nand_resource.start = IXP4XX_EXP_BUS_BASE(3), ixdp425_flash_nand_resource.end = IXP4XX_EXP_BUS_BASE(3) + 0x10 - 1; gpio_line_config(IXDP425_NAND_NCE_PIN, IXP4XX_GPIO_OUT); /* Configure expansion bus for NAND Flash */ *IXP4XX_EXP_CS3 = IXP4XX_EXP_BUS_CS_EN | IXP4XX_EXP_BUS_STROBE_T(1) | /* extend by 1 clock */ IXP4XX_EXP_BUS_CYCLES(0) | /* Intel cycles */ IXP4XX_EXP_BUS_SIZE(0) | /* 512bytes addr space*/ IXP4XX_EXP_BUS_WR_EN | IXP4XX_EXP_BUS_BYTE_EN; /* 8 bit data bus */ #endif if (cpu_is_ixp43x()) { ixdp425_uart.num_resources = 1; ixdp425_uart_data[1].flags = 0; } platform_add_devices(ixdp425_devices, ARRAY_SIZE(ixdp425_devices)); } #ifdef CONFIG_ARCH_IXDP425 MACHINE_START(IXDP425, "Intel IXDP425 Development Platform") /* Maintainer: MontaVista Software, Inc. */ .phys_io = IXP4XX_PERIPHERAL_BASE_PHYS, .io_pg_offst = ((IXP4XX_PERIPHERAL_BASE_VIRT) >> 18) & 0xfffc, .map_io = ixp4xx_map_io, .init_irq = ixp4xx_init_irq, .timer = &ixp4xx_timer, .boot_params = 0x0100, .init_machine = ixdp425_init, MACHINE_END #endif #ifdef CONFIG_MACH_IXDP465 MACHINE_START(IXDP465, "Intel IXDP465 Development Platform") /* Maintainer: MontaVista Software, Inc. */ .phys_io = IXP4XX_PERIPHERAL_BASE_PHYS, .io_pg_offst = ((IXP4XX_PERIPHERAL_BASE_VIRT) >> 18) & 0xfffc, .map_io = ixp4xx_map_io, .init_irq = ixp4xx_init_irq, .timer = &ixp4xx_timer, .boot_params = 0x0100, .init_machine = ixdp425_init, MACHINE_END #endif #ifdef CONFIG_ARCH_PRPMC1100 MACHINE_START(IXCDP1100, "Intel IXCDP1100 Development Platform") /* Maintainer: MontaVista Software, Inc. */ .phys_io = IXP4XX_PERIPHERAL_BASE_PHYS, .io_pg_offst = ((IXP4XX_PERIPHERAL_BASE_VIRT) >> 18) & 0xfffc, .map_io = ixp4xx_map_io, .init_irq = ixp4xx_init_irq, .timer = &ixp4xx_timer, .boot_params = 0x0100, .init_machine = ixdp425_init, MACHINE_END #endif #ifdef CONFIG_MACH_KIXRP435 MACHINE_START(KIXRP435, "Intel KIXRP435 Reference Platform") /* Maintainer: MontaVista Software, Inc. */ .phys_io = IXP4XX_PERIPHERAL_BASE_PHYS, .io_pg_offst = ((IXP4XX_PERIPHERAL_BASE_VIRT) >> 18) & 0xfffc, .map_io = ixp4xx_map_io, .init_irq = ixp4xx_init_irq, .timer = &ixp4xx_timer, .boot_params = 0x0100, .init_machine = ixdp425_init, MACHINE_END #endif