/* * 7990.h -- LANCE ethernet IC generic routines. * This is an attempt to separate out the bits of various ethernet * drivers that are common because they all use the AMD 7990 LANCE * (Local Area Network Controller for Ethernet) chip. * * Copyright (C) 05/1998 Peter Maydell <pmaydell@chiark.greenend.org.uk> * * Most of this stuff was obtained by looking at other LANCE drivers, * in particular a2065.[ch]. The AMD C-LANCE datasheet was also helpful. */ #ifndef _7990_H #define _7990_H /* The lance only has two register locations. We communicate mostly via memory. */ #define LANCE_RDP 0 /* Register Data Port */ #define LANCE_RAP 2 /* Register Address Port */ /* Transmit/receive ring definitions. * We allow the specific drivers to override these defaults if they want to. * NB: according to lance.c, increasing the number of buffers is a waste * of space and reduces the chance that an upper layer will be able to * reorder queued Tx packets based on priority. [Clearly there is a minimum * limit too: too small and we drop rx packets and can't tx at full speed.] * 4+4 seems to be the usual setting; the atarilance driver uses 3 and 5. */ /* Blast! This won't work. The problem is that we can't specify a default * setting because that would cause the lance_init_block struct to be * too long (and overflow the RAM on shared-memory cards like the HP LANCE. */ #ifndef LANCE_LOG_TX_BUFFERS #define LANCE_LOG_TX_BUFFERS 1 #define LANCE_LOG_RX_BUFFERS 3 #endif #define TX_RING_SIZE (1<<LANCE_LOG_TX_BUFFERS) #define RX_RING_SIZE (1<<LANCE_LOG_RX_BUFFERS) #define TX_RING_MOD_MASK (TX_RING_SIZE - 1) #define RX_RING_MOD_MASK (RX_RING_SIZE - 1) #define TX_RING_LEN_BITS ((LANCE_LOG_TX_BUFFERS) << 29) #define RX_RING_LEN_BITS ((LANCE_LOG_RX_BUFFERS) << 29) #define PKT_BUFF_SIZE (1544) #define RX_BUFF_SIZE PKT_BUFF_SIZE #define TX_BUFF_SIZE PKT_BUFF_SIZE /* Each receive buffer is described by a receive message descriptor (RMD) */ struct lance_rx_desc { volatile unsigned short rmd0; /* low address of packet */ volatile unsigned char rmd1_bits; /* descriptor bits */ volatile unsigned char rmd1_hadr; /* high address of packet */ volatile short length; /* This length is 2s complement (negative)! * Buffer length */ volatile unsigned short mblength; /* Actual number of bytes received */ }; /* Ditto for TMD: */ struct lance_tx_desc { volatile unsigned short tmd0; /* low address of packet */ volatile unsigned char tmd1_bits; /* descriptor bits */ volatile unsigned char tmd1_hadr; /* high address of packet */ volatile short length; /* Length is 2s complement (negative)! */ volatile unsigned short misc; }; /* There are three memory structures accessed by the LANCE: * the initialization block, the receive and transmit descriptor rings, * and the data buffers themselves. In fact we might as well put the * init block,the Tx and Rx rings and the buffers together in memory: */ struct lance_init_block { volatile unsigned short mode; /* Pre-set mode (reg. 15) */ volatile unsigned char phys_addr[6]; /* Physical ethernet address */ volatile unsigned filter[2]; /* Multicast filter (64 bits) */ /* Receive and transmit ring base, along with extra bits. */ volatile unsigned short rx_ptr; /* receive descriptor addr */ volatile unsigned short rx_len; /* receive len and high addr */ volatile unsigned short tx_ptr; /* transmit descriptor addr */ volatile unsigned short tx_len; /* transmit len and high addr */ /* The Tx and Rx ring entries must be aligned on 8-byte boundaries. * This will be true if this whole struct is 8-byte aligned. */ volatile struct lance_tx_desc btx_ring[TX_RING_SIZE]; volatile struct lance_rx_desc brx_ring[RX_RING_SIZE]; volatile char tx_buf [TX_RING_SIZE][TX_BUFF_SIZE]; volatile char rx_buf [RX_RING_SIZE][RX_BUFF_SIZE]; /* we use this just to make the struct big enough that we can move its startaddr * in order to force alignment to an eight byte boundary. */ }; /* This is where we keep all the stuff the driver needs to know about. * I'm definitely unhappy about the mechanism for allowing specific * drivers to add things... */ struct lance_private { char *name; unsigned long base; volatile struct lance_init_block *init_block; /* CPU address of RAM */ volatile struct lance_init_block *lance_init_block; /* LANCE address of RAM */ int rx_new, tx_new; int rx_old, tx_old; int lance_log_rx_bufs, lance_log_tx_bufs; int rx_ring_mod_mask, tx_ring_mod_mask; int tpe; /* TPE is selected */ int auto_select; /* cable-selection is by carrier */ unsigned short busmaster_regval; unsigned int irq; /* IRQ to register */ /* This is because the HP LANCE is disgusting and you have to check * a DIO-specific register every time you read/write the LANCE regs :-< * [could we get away with making these some sort of macro?] */ void (*writerap)(void *, unsigned short); void (*writerdp)(void *, unsigned short); unsigned short (*readrdp)(void *); spinlock_t devlock; char tx_full; }; /* * Am7990 Control and Status Registers */ #define LE_CSR0 0x0000 /* LANCE Controller Status */ #define LE_CSR1 0x0001 /* IADR[15:0] (bit0==0 ie word aligned) */ #define LE_CSR2 0x0002 /* IADR[23:16] (high bits reserved) */ #define LE_CSR3 0x0003 /* Misc */ /* * Bit definitions for CSR0 (LANCE Controller Status) */ #define LE_C0_ERR 0x8000 /* Error = BABL | CERR | MISS | MERR */ #define LE_C0_BABL 0x4000 /* Babble: Transmitted too many bits */ #define LE_C0_CERR 0x2000 /* No Heartbeat (10BASE-T) */ #define LE_C0_MISS 0x1000 /* Missed Frame (no rx buffer to put it in) */ #define LE_C0_MERR 0x0800 /* Memory Error */ #define LE_C0_RINT 0x0400 /* Receive Interrupt */ #define LE_C0_TINT 0x0200 /* Transmit Interrupt */ #define LE_C0_IDON 0x0100 /* Initialization Done */ #define LE_C0_INTR 0x0080 /* Interrupt Flag = BABL | MISS | MERR | RINT | TINT | IDON */ #define LE_C0_INEA 0x0040 /* Interrupt Enable */ #define LE_C0_RXON 0x0020 /* Receive On */ #define LE_C0_TXON 0x0010 /* Transmit On */ #define LE_C0_TDMD 0x0008 /* Transmit Demand */ #define LE_C0_STOP 0x0004 /* Stop */ #define LE_C0_STRT 0x0002 /* Start */ #define LE_C0_INIT 0x0001 /* Initialize */ /* * Bit definitions for CSR3 */ #define LE_C3_BSWP 0x0004 /* Byte Swap (on for big endian byte order) */ #define LE_C3_ACON 0x0002 /* ALE Control (on for active low ALE) */ #define LE_C3_BCON 0x0001 /* Byte Control */ /* * Mode Flags */ #define LE_MO_PROM 0x8000 /* Promiscuous Mode */ /* these next ones 0x4000 -- 0x0080 are not available on the LANCE 7990, * but they are in NetBSD's am7990.h, presumably for backwards-compatible chips */ #define LE_MO_DRCVBC 0x4000 /* disable receive broadcast */ #define LE_MO_DRCVPA 0x2000 /* disable physical address detection */ #define LE_MO_DLNKTST 0x1000 /* disable link status */ #define LE_MO_DAPC 0x0800 /* disable automatic polarity correction */ #define LE_MO_MENDECL 0x0400 /* MENDEC loopback mode */ #define LE_MO_LRTTSEL 0x0200 /* lower RX threshold / TX mode selection */ #define LE_MO_PSEL1 0x0100 /* port selection bit1 */ #define LE_MO_PSEL0 0x0080 /* port selection bit0 */ /* and this one is from the C-LANCE data sheet... */ #define LE_MO_EMBA 0x0080 /* Enable Modified Backoff Algorithm (C-LANCE, not original LANCE) */ #define LE_MO_INTL 0x0040 /* Internal Loopback */ #define LE_MO_DRTY 0x0020 /* Disable Retry */ #define LE_MO_FCOLL 0x0010 /* Force Collision */ #define LE_MO_DXMTFCS 0x0008 /* Disable Transmit CRC */ #define LE_MO_LOOP 0x0004 /* Loopback Enable */ #define LE_MO_DTX 0x0002 /* Disable Transmitter */ #define LE_MO_DRX 0x0001 /* Disable Receiver */ /* * Receive Flags */ #define LE_R1_OWN 0x80 /* LANCE owns the descriptor */ #define LE_R1_ERR 0x40 /* Error */ #define LE_R1_FRA 0x20 /* Framing Error */ #define LE_R1_OFL 0x10 /* Overflow Error */ #define LE_R1_CRC 0x08 /* CRC Error */ #define LE_R1_BUF 0x04 /* Buffer Error */ #define LE_R1_SOP 0x02 /* Start of Packet */ #define LE_R1_EOP 0x01 /* End of Packet */ #define LE_R1_POK 0x03 /* Packet is complete: SOP + EOP */ /* * Transmit Flags */ #define LE_T1_OWN 0x80 /* LANCE owns the descriptor */ #define LE_T1_ERR 0x40 /* Error */ #define LE_T1_RES 0x20 /* Reserved, LANCE writes this with a zero */ #define LE_T1_EMORE 0x10 /* More than one retry needed */ #define LE_T1_EONE 0x08 /* One retry needed */ #define LE_T1_EDEF 0x04 /* Deferred */ #define LE_T1_SOP 0x02 /* Start of Packet */ #define LE_T1_EOP 0x01 /* End of Packet */ #define LE_T1_POK 0x03 /* Packet is complete: SOP + EOP */ /* * Error Flags */ #define LE_T3_BUF 0x8000 /* Buffer Error */ #define LE_T3_UFL 0x4000 /* Underflow Error */ #define LE_T3_LCOL 0x1000 /* Late Collision */ #define LE_T3_CLOS 0x0800 /* Loss of Carrier */ #define LE_T3_RTY 0x0400 /* Retry Error */ #define LE_T3_TDR 0x03ff /* Time Domain Reflectometry */ /* Miscellaneous useful macros */ #define TX_BUFFS_AVAIL ((lp->tx_old<=lp->tx_new)?\ lp->tx_old+lp->tx_ring_mod_mask-lp->tx_new:\ lp->tx_old - lp->tx_new-1) /* The LANCE only uses 24 bit addresses. This does the obvious thing. */ #define LANCE_ADDR(x) ((int)(x) & ~0xff000000) /* Now the prototypes we export */ extern int lance_open(struct net_device *dev); extern int lance_close (struct net_device *dev); extern int lance_start_xmit (struct sk_buff *skb, struct net_device *dev); extern void lance_set_multicast (struct net_device *dev); extern void lance_tx_timeout(struct net_device *dev); #ifdef CONFIG_NET_POLL_CONTROLLER extern void lance_poll(struct net_device *dev); #endif #endif /* ndef _7990_H */