Merge branch 'linus' into tracing/hw-breakpoints

Conflicts:
	arch/x86/Kconfig
	arch/x86/kernel/traps.c
	arch/x86/power/cpu.c
	arch/x86/power/cpu_32.c
	kernel/Makefile

Semantic conflict:
	arch/x86/kernel/hw_breakpoint.c

Merge reason: Resolve the conflicts, move from put_cpu_no_sched() to
              put_cpu() in arch/x86/kernel/hw_breakpoint.c.

Signed-off-by: Ingo Molnar <mingo@elte.hu>

1 files changed, 190 insertions, 10 deletions

diff --git a/arch/arm/mach-mx3/mx31pdk.c b/arch/arm/mach-mx3/mx31pdk.c
index bc63f178569..c19838d2e36 100644
--- a/arch/arm/mach-mx3/mx31pdk.c
+++ b/arch/arm/mach-mx3/mx31pdk.c
@@ -20,6 +20,9 @@
 #include <linux/init.h>
 #include <linux/clk.h>
 #include <linux/irq.h>
+#include <linux/gpio.h>
+#include <linux/smsc911x.h>
+#include <linux/platform_device.h>
 
 #include <mach/hardware.h>
 #include <asm/mach-types.h>
@@ -41,21 +44,192 @@
  * @ingroup System
  */
 
+static int mx31pdk_pins[] = {
+	/* UART1 */
+	MX31_PIN_CTS1__CTS1,
+	MX31_PIN_RTS1__RTS1,
+	MX31_PIN_TXD1__TXD1,
+	MX31_PIN_RXD1__RXD1,
+	IOMUX_MODE(MX31_PIN_GPIO1_1, IOMUX_CONFIG_GPIO),
+};
+
 static struct imxuart_platform_data uart_pdata = {
 	.flags = IMXUART_HAVE_RTSCTS,
 };
 
-static int uart_pins[] = {
-	MX31_PIN_CTS1__CTS1,
-	MX31_PIN_RTS1__RTS1,
-	MX31_PIN_TXD1__TXD1,
-	MX31_PIN_RXD1__RXD1
+/*
+ * Support for the SMSC9217 on the Debug board.
+ */
+
+static struct smsc911x_platform_config smsc911x_config = {
+	.irq_polarity	= SMSC911X_IRQ_POLARITY_ACTIVE_LOW,
+	.irq_type	= SMSC911X_IRQ_TYPE_PUSH_PULL,
+	.flags		= SMSC911X_USE_16BIT | SMSC911X_FORCE_INTERNAL_PHY,
+	.phy_interface	= PHY_INTERFACE_MODE_MII,
+};
+
+static struct resource smsc911x_resources[] = {
+	{
+		.start		= LAN9217_BASE_ADDR,
+		.end		= LAN9217_BASE_ADDR + 0xff,
+		.flags		= IORESOURCE_MEM,
+	}, {
+		.start		= EXPIO_INT_ENET,
+		.end		= EXPIO_INT_ENET,
+		.flags		= IORESOURCE_IRQ,
+	},
+};
+
+static struct platform_device smsc911x_device = {
+	.name		= "smsc911x",
+	.id		= -1,
+	.num_resources	= ARRAY_SIZE(smsc911x_resources),
+	.resource	= smsc911x_resources,
+	.dev		= {
+		.platform_data = &smsc911x_config,
+	},
 };
 
-static inline void mxc_init_imx_uart(void)
+/*
+ * Routines for the CPLD on the debug board. It contains a CPLD handling
+ * LEDs, switches, interrupts for Ethernet.
+ */
+
+static void mx31pdk_expio_irq_handler(uint32_t irq, struct irq_desc *desc)
 {
-	mxc_iomux_setup_multiple_pins(uart_pins, ARRAY_SIZE(uart_pins), "uart-0");
-	mxc_register_device(&mxc_uart_device0, &uart_pdata);
+	uint32_t imr_val;
+	uint32_t int_valid;
+	uint32_t expio_irq;
+
+	imr_val = __raw_readw(CPLD_INT_MASK_REG);
+	int_valid = __raw_readw(CPLD_INT_STATUS_REG) & ~imr_val;
+
+	expio_irq = MXC_EXP_IO_BASE;
+	for (; int_valid != 0; int_valid >>= 1, expio_irq++) {
+		if ((int_valid & 1) == 0)
+			continue;
+		generic_handle_irq(expio_irq);
+	}
+}
+
+/*
+ * Disable an expio pin's interrupt by setting the bit in the imr.
+ * @param irq           an expio virtual irq number
+ */
+static void expio_mask_irq(uint32_t irq)
+{
+	uint16_t reg;
+	uint32_t expio = MXC_IRQ_TO_EXPIO(irq);
+
+	/* mask the interrupt */
+	reg = __raw_readw(CPLD_INT_MASK_REG);
+	reg |= 1 << expio;
+	__raw_writew(reg, CPLD_INT_MASK_REG);
+}
+
+/*
+ * Acknowledge an expanded io pin's interrupt by clearing the bit in the isr.
+ * @param irq           an expanded io virtual irq number
+ */
+static void expio_ack_irq(uint32_t irq)
+{
+	uint32_t expio = MXC_IRQ_TO_EXPIO(irq);
+
+	/* clear the interrupt status */
+	__raw_writew(1 << expio, CPLD_INT_RESET_REG);
+	__raw_writew(0, CPLD_INT_RESET_REG);
+	/* mask the interrupt */
+	expio_mask_irq(irq);
+}
+
+/*
+ * Enable a expio pin's interrupt by clearing the bit in the imr.
+ * @param irq           a expio virtual irq number
+ */
+static void expio_unmask_irq(uint32_t irq)
+{
+	uint16_t reg;
+	uint32_t expio = MXC_IRQ_TO_EXPIO(irq);
+
+	/* unmask the interrupt */
+	reg = __raw_readw(CPLD_INT_MASK_REG);
+	reg &= ~(1 << expio);
+	__raw_writew(reg, CPLD_INT_MASK_REG);
+}
+
+static struct irq_chip expio_irq_chip = {
+	.ack = expio_ack_irq,
+	.mask = expio_mask_irq,
+	.unmask = expio_unmask_irq,
+};
+
+static int __init mx31pdk_init_expio(void)
+{
+	int i;
+	int ret;
+
+	/* Check if there's a debug board connected */
+	if ((__raw_readw(CPLD_MAGIC_NUMBER1_REG) != 0xAAAA) ||
+	    (__raw_readw(CPLD_MAGIC_NUMBER2_REG) != 0x5555) ||
+	    (__raw_readw(CPLD_MAGIC_NUMBER3_REG) != 0xCAFE)) {
+		/* No Debug board found */
+		return -ENODEV;
+	}
+
+	pr_info("i.MX31PDK Debug board detected, rev = 0x%04X\n",
+		__raw_readw(CPLD_CODE_VER_REG));
+
+	/*
+	 * Configure INT line as GPIO input
+	 */
+	ret = gpio_request(IOMUX_TO_GPIO(MX31_PIN_GPIO1_1), "sms9217-irq");
+	if (ret)
+		pr_warning("could not get LAN irq gpio\n");
+	else
+		gpio_direction_input(IOMUX_TO_GPIO(MX31_PIN_GPIO1_1));
+
+	/* Disable the interrupts and clear the status */
+	__raw_writew(0, CPLD_INT_MASK_REG);
+	__raw_writew(0xFFFF, CPLD_INT_RESET_REG);
+	__raw_writew(0, CPLD_INT_RESET_REG);
+	__raw_writew(0x1F, CPLD_INT_MASK_REG);
+	for (i = MXC_EXP_IO_BASE;
+	     i < (MXC_EXP_IO_BASE + MXC_MAX_EXP_IO_LINES);
+	     i++) {
+		set_irq_chip(i, &expio_irq_chip);
+		set_irq_handler(i, handle_level_irq);
+		set_irq_flags(i, IRQF_VALID);
+	}
+	set_irq_type(EXPIO_PARENT_INT, IRQ_TYPE_LEVEL_LOW);
+	set_irq_chained_handler(EXPIO_PARENT_INT, mx31pdk_expio_irq_handler);
+
+	return 0;
+}
+
+/*
+ * This structure defines the MX31 memory map.
+ */
+static struct map_desc mx31pdk_io_desc[] __initdata = {
+	{
+		.virtual = SPBA0_BASE_ADDR_VIRT,
+		.pfn = __phys_to_pfn(SPBA0_BASE_ADDR),
+		.length = SPBA0_SIZE,
+		.type = MT_DEVICE_NONSHARED,
+	}, {
+		.virtual = CS5_BASE_ADDR_VIRT,
+		.pfn = __phys_to_pfn(CS5_BASE_ADDR),
+		.length = CS5_SIZE,
+		.type = MT_DEVICE,
+	},
+};
+
+/*
+ * Set up static virtual mappings.
+ */
+static void __init mx31pdk_map_io(void)
+{
+	mx31_map_io();
+	iotable_init(mx31pdk_io_desc, ARRAY_SIZE(mx31pdk_io_desc));
 }
 
 /*!
@@ -63,7 +237,13 @@ static inline void mxc_init_imx_uart(void)
  */
 static void __init mxc_board_init(void)
 {
-	mxc_init_imx_uart();
+	mxc_iomux_setup_multiple_pins(mx31pdk_pins, ARRAY_SIZE(mx31pdk_pins),
+				      "mx31pdk");
+
+	mxc_register_device(&mxc_uart_device0, &uart_pdata);
+
+	if (!mx31pdk_init_expio())
+		platform_device_register(&smsc911x_device);
 }
 
 static void __init mx31pdk_timer_init(void)
@@ -84,7 +264,7 @@ MACHINE_START(MX31_3DS, "Freescale MX31PDK (3DS)")
 	.phys_io	= AIPS1_BASE_ADDR,
 	.io_pg_offst	= ((AIPS1_BASE_ADDR_VIRT) >> 18) & 0xfffc,
 	.boot_params    = PHYS_OFFSET + 0x100,
-	.map_io         = mxc_map_io,
+	.map_io         = mx31pdk_map_io,
 	.init_irq       = mxc_init_irq,
 	.init_machine   = mxc_board_init,
 	.timer          = &mx31pdk_timer,