USB: ISP1760 HCD driver

This driver has been written from scratch and supports the ISP1760. ISP1761
might (should) work as well but the OTG isn't supported. Also ISO packets are
not. However, it works on my little PowerPC board.

Signed-off-by: Sebastian Siewior <bigeasy@linutronix.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

1 files changed, 206 insertions, 0 deletions

diff --git a/drivers/usb/host/isp1760-hcd.h b/drivers/usb/host/isp1760-hcd.h
new file mode 100644
index 00000000000..3d86d0f6b14
--- /dev/null
+++ b/drivers/usb/host/isp1760-hcd.h
@@ -0,0 +1,206 @@
+#ifndef _ISP1760_HCD_H_
+#define _ISP1760_HCD_H_
+
+/* exports for if */
+struct usb_hcd *isp1760_register(u64 res_start, u64 res_len, int irq,
+		u64 irqflags, struct device *dev, const char *busname);
+int init_kmem_once(void);
+void deinit_kmem_cache(void);
+
+/* EHCI capability registers */
+#define HC_CAPLENGTH		0x00
+#define HC_HCSPARAMS		0x04
+#define HC_HCCPARAMS		0x08
+
+/* EHCI operational registers */
+#define HC_USBCMD		0x20
+#define HC_USBSTS		0x24
+#define HC_FRINDEX		0x2c
+#define HC_CONFIGFLAG		0x60
+#define HC_PORTSC1		0x64
+#define HC_ISO_PTD_DONEMAP_REG	0x130
+#define HC_ISO_PTD_SKIPMAP_REG	0x134
+#define HC_ISO_PTD_LASTPTD_REG	0x138
+#define HC_INT_PTD_DONEMAP_REG	0x140
+#define HC_INT_PTD_SKIPMAP_REG	0x144
+#define HC_INT_PTD_LASTPTD_REG	0x148
+#define HC_ATL_PTD_DONEMAP_REG	0x150
+#define HC_ATL_PTD_SKIPMAP_REG	0x154
+#define HC_ATL_PTD_LASTPTD_REG	0x158
+
+/* Configuration Register */
+#define HC_HW_MODE_CTRL		0x300
+#define ALL_ATX_RESET		(1 << 31)
+#define HW_DATA_BUS_32BIT	(1 << 8)
+#define HW_DACK_POL_HIGH	(1 << 6)
+#define HW_DREQ_POL_HIGH	(1 << 5)
+#define HW_INTR_HIGH_ACT	(1 << 2)
+#define HW_INTR_EDGE_TRIG	(1 << 1)
+#define HW_GLOBAL_INTR_EN	(1 << 0)
+
+#define HC_CHIP_ID_REG		0x304
+#define HC_SCRATCH_REG		0x308
+
+#define HC_RESET_REG		0x30c
+#define SW_RESET_RESET_HC	(1 << 1)
+#define SW_RESET_RESET_ALL	(1 << 0)
+
+#define HC_BUFFER_STATUS_REG	0x334
+#define ATL_BUFFER		0x1
+#define INT_BUFFER		0x2
+#define ISO_BUFFER		0x4
+#define BUFFER_MAP		0x7
+
+#define HC_MEMORY_REG		0x33c
+#define HC_PORT1_CTRL		0x374
+#define PORT1_POWER		(3 << 3)
+#define PORT1_INIT1		(1 << 7)
+#define PORT1_INIT2		(1 << 23)
+
+/* Interrupt Register */
+#define HC_INTERRUPT_REG	0x310
+
+#define HC_INTERRUPT_ENABLE	0x314
+#define INTERRUPT_ENABLE_MASK	(HC_INTL_INT | HC_ATL_INT | HC_EOT_INT)
+#define FINAL_HW_CONFIG	(HW_GLOBAL_INTR_EN | HW_DATA_BUS_32BIT)
+
+#define HC_ISO_INT		(1 << 9)
+#define HC_ATL_INT		(1 << 8)
+#define HC_INTL_INT		(1 << 7)
+#define HC_EOT_INT		(1 << 3)
+#define HC_SOT_INT		(1 << 1)
+
+#define HC_ISO_IRQ_MASK_OR_REG	0x318
+#define HC_INT_IRQ_MASK_OR_REG	0x31C
+#define HC_ATL_IRQ_MASK_OR_REG	0x320
+#define HC_ISO_IRQ_MASK_AND_REG	0x324
+#define HC_INT_IRQ_MASK_AND_REG	0x328
+#define HC_ATL_IRQ_MASK_AND_REG	0x32C
+
+/* Register sets */
+#define HC_BEGIN_OF_ATL		0x0c00
+#define HC_BEGIN_OF_INT		0x0800
+#define HC_BEGIN_OF_ISO		0x0400
+#define HC_BEGIN_OF_PAYLOAD	0x1000
+
+/* urb state*/
+#define DELETE_URB		(0x0008)
+#define NO_TRANSFER_ACTIVE	(0xffffffff)
+
+#define ATL_REGS_OFFSET		(0xc00)
+#define INT_REGS_OFFSET		(0x800)
+
+/* Philips Transfer Descriptor (PTD) */
+struct ptd {
+	__le32 dw0;
+	__le32 dw1;
+	__le32 dw2;
+	__le32 dw3;
+	__le32 dw4;
+	__le32 dw5;
+	__le32 dw6;
+	__le32 dw7;
+};
+
+struct inter_packet_info {
+	void *data_buffer;
+	u32 payload;
+#define PTD_FIRE_NEXT		(1 << 0)
+#define PTD_URB_FINISHED	(1 << 1)
+	struct urb *urb;
+	struct isp1760_qh *qh;
+	struct isp1760_qtd *qtd;
+};
+
+
+typedef void (packet_enqueue)(struct usb_hcd *hcd, struct isp1760_qh *qh,
+		struct isp1760_qtd *qtd);
+
+#define isp1760_info(priv, fmt, args...) \
+	dev_info(priv_to_hcd(priv)->self.controller, fmt, ##args)
+
+#define isp1760_err(priv, fmt, args...) \
+	dev_err(priv_to_hcd(priv)->self.controller, fmt, ##args)
+
+/* chip memory management */
+struct memory_chunk {
+	unsigned int start;
+	unsigned int size;
+	unsigned int free;
+};
+
+/*
+ * 60kb divided in:
+ * - 32 blocks @ 256  bytes
+ * - 20 blocks @ 1024 bytes
+ * -  4 blocks @ 8192 bytes
+ */
+
+#define BLOCK_1_NUM 32
+#define BLOCK_2_NUM 20
+#define BLOCK_3_NUM 4
+
+#define BLOCK_1_SIZE 256
+#define BLOCK_2_SIZE 1024
+#define BLOCK_3_SIZE 8192
+#define BLOCKS (BLOCK_1_NUM + BLOCK_2_NUM + BLOCK_3_NUM)
+#define PAYLOAD_SIZE 0xf000
+
+/* I saw if some reloads if the pointer was negative */
+#define ISP1760_NULL_POINTER	(0x400)
+
+/* ATL */
+/* DW0 */
+#define PTD_VALID			1
+#define PTD_LENGTH(x)			(((u32) x) << 3)
+#define PTD_MAXPACKET(x)		(((u32) x) << 18)
+#define PTD_MULTI(x)			(((u32) x) << 29)
+#define PTD_ENDPOINT(x)			(((u32)	x) << 31)
+/* DW1 */
+#define PTD_DEVICE_ADDR(x)		(((u32) x) << 3)
+#define PTD_PID_TOKEN(x)		(((u32) x) << 10)
+#define PTD_TRANS_BULK			((u32) 2 << 12)
+#define PTD_TRANS_INT			((u32) 3 << 12)
+#define PTD_TRANS_SPLIT			((u32) 1 << 14)
+#define PTD_SE_USB_LOSPEED		((u32) 2 << 16)
+#define PTD_PORT_NUM(x)			(((u32) x) << 18)
+#define PTD_HUB_NUM(x)			(((u32) x) << 25)
+#define PTD_PING(x)			(((u32) x) << 26)
+/* DW2 */
+#define PTD_RL_CNT(x)			(((u32) x) << 25)
+#define PTD_DATA_START_ADDR(x)		(((u32) x) << 8)
+#define BASE_ADDR			0x1000
+/* DW3 */
+#define PTD_CERR(x)			(((u32) x) << 23)
+#define PTD_NAC_CNT(x)			(((u32) x) << 19)
+#define PTD_ACTIVE			((u32) 1 << 31)
+#define PTD_DATA_TOGGLE(x)		(((u32) x) << 25)
+
+#define DW3_HALT_BIT			(1 << 30)
+#define DW3_ERROR_BIT			(1 << 28)
+#define DW3_QTD_ACTIVE			(1 << 31)
+
+#define INT_UNDERRUN			(1 << 2)
+#define INT_BABBLE			(1 << 1)
+#define INT_EXACT			(1 << 0)
+
+#define DW1_GET_PID(x)			(((x) >> 10) & 0x3)
+#define PTD_XFERRED_LENGTH(x)		((x) & 0x7fff)
+#define PTD_XFERRED_LENGTH_LO(x)	((x) & 0x7ff)
+
+#define SETUP_PID	(2)
+#define IN_PID		(1)
+#define OUT_PID		(0)
+#define GET_QTD_TOKEN_TYPE(x)	((x) & 0x3)
+
+#define DATA_TOGGLE		(1 << 31)
+#define GET_DATA_TOGGLE(x)	((x) >> 31)
+
+/* Errata 1 */
+#define RL_COUNTER	(0)
+#define NAK_COUNTER	(0)
+#define ERR_COUNTER	(2)
+
+#define HC_ATL_PL_SIZE	(8192)
+
+#endif