| Age | Commit message (Collapse) | Author |
|---|
|
Two issues... we never took care to take down engines in suspend
and bring them back in resume. This was part of the display
corruption that could be seen briefly on resume. The other issue
that made the "noise" corruption was bad ordering of resume steps.
This patch simplifies (removing needless re-init) resume actions
and makes explicit the suspend and resume steps. It also adds
code to track which engines are up and push them down in suspend
and bring them back in resume.
The result is no more corruption of display buffer in suspend, it
comes back completely clean.
Signed-off-by: Andy Green <andy@openmoko.com>
|
|
mach-gta02 meddles with the regulator platform struct after
it is defined, leading to LCM power getting lost in suspend
despite I set it to be left up. Fixing this finally removes
the incredibly stubborn white LCM on suspend "flash".
This is also going to be implicated in Sean McNeil's
experience of monochromatic LCM after resume, which was
previously attacked by resetting and re-initing the LCM
from scratch.
In addition, I realized that we take down core_1v3 in
pcf50633 suspend action, this is happening near the
start of suspend, so we are in a meta-race to finish
suspend in a controlled way before the caps on core_1v3
run out (I only saw 23.3uF total). If it's true, this
is where the weirdo sensitivity to timing during
suspend is coming from.
Therefore in this patch we also remove sleeps and
dev_info() etc (which have to flush on serial console)
from the pc50633 isr workqueue if we are in pcf50633
driver suspend state 1, ie, suspending... because we
don't have time for it.
Signed-off-by: Andy Green <andy@openmoko.com>
|
|
Glamo MCI has a resume order dependncy on pcf50633, it has to be able to
power the SD slot via it.
Signed-off-by: Andy Green <andy@openmoko.com>
|
|
Adds the resume callback stuff to glamo, then changes
jbt6k74 to no longer use a sleeping workqueue, but to
make its resume actions dependent on pcf50633 and
glamo resume (for backlight and communication to LCM
respectively)
Signed-off-by: Andy Green <andy@openmoko.com>
|
|
Signed-Off-By: Holger Freyther <zecke@openmoko.org>
|
|
Signed-off-by: Andy Green <andy@openmoko.com>
|
|
Glamo "cmd mode" is modal, but nothing took care about locking.
Also cmd mode was entered recursively in rotate_lcd().
Signed-off-by: Andy Green <andy@openmoko.com>
|
|
From: Andy Green <andy@openmoko.com>
Sigend-off-by: Andy Green <andy@openmoko.com>
|
|
|
|
|
|
|
|
|
|
[ FIXME:
include/asm-arm/arch-s3c2410/irqs.h shouldn't contain device-specific
changes. ]
This is a Linux kernel driver for the Smedia Glamo336x / Glamo337x
multi-function peripheral device.
Signed-off-by: Harald Welte <laforge@openmoko.org>
|
